SESSION
Owners Manual
THE ART OF BALANCE
1
º
º
º
º
º
º
IMPORTANT SAFETY NOTICE
WARNING
The use of the YBIKE Session can be a hazardous activity and precautions should be taken to
avoid dangerous situations. Be sure to read the entire manual before riding. Please pay close
attention to the following notices in particular:
SAFETY PRECAUTIONS:
WARNING! This ride-on is intended to be assembled by an adult.
For ages 2+, max. weight 20kg. Children riding the YBIKE Session should have constant adult
supervision. A responsible adult must inspect the YBIKE Session prior to use, to ensure that
all parts are fully assembled and tightened to prevent accidents.
Always wear proper protective gear such as a helmet, wrist pads, elbow pads and kneepads
as well as appropriate clothing such as a long sleeve shirt, gloves, long pants and trainers or
closed footwear. Do not ride barefoot or in sandals.
DO NOT use the YBIKE Session on slippery, wet or uneven ground with gravel. Never use
near swimming pools or other bodies of water.
DO NOT ride the YBIKE Session with one or no hands. Hold the handlebars tightly with two
hands.
Ride YBIKE Session only on flat and level ground. DO NOT ride YBIKE Session on slopes. DO
NOT go down a long descending slope, driveways or hills. Please be careful when passing
these areas.
Keep your child away from doors, windows and furniture to avoid collision with glass. Block
stairs/steps securely to avoid injury.
2
º
º
º
º
º
º
º
º
Keep the child away from hot places, radiators, space heaters and fireplaces to avoid burns.
Avoid direct, high impact collisions into walls, sidewalks and other objects.
Ensure that the handle is securely fixed and that it moves smoothly by turning it left and
right before riding the YBIKE Session.
DO NOT use attachments not included in packaging or attempt to do any modifications
yourself, as this may compromise the safety of the ride-on.
Make sure all components are assembled correctly and secured properly before riding.
Never use near cars, motor vehicles, roadways, near streets or trac. DO NOT use in trac.
Never allow more than one child to ride on YBIKE Session at any time. Not to be used by
children weighing more than 20kgs due to insucient strength.
One time assembly only. This product should only be assembled once.
WARNING: Chocking Hazards—Small parts. Not for children younger than 2 years old.
Injury may occur if these precautions are not observed.
NOTE: Any photos of the YBIKE Session or decals in the owner’s manual are Intended to be
used as a reference only, and there may be some dierences to the unit you purchased.
WARNING
YBIKE Session Parts List & Components
Remove all of the parts from the box, lay them on the floor and check that all the components
listed are there.
1
2
3
4
3.3
3.1
3.2
5
7
6
8
1110
9
12
3
1 Front Fork
2 Rear Frame
3 Wheels
3.1 Wheel Bolts
3.2 Locking Washers
3.3 Wheel Spacers
4 Spanners
5 Allen Keys Large
6 Plastic Stoppers
7 Allen Keys Small
8 Seat Bolts
9 Seat Nuts
10 Front Fork Nuts
11 Front Fork Bolts
12 Seat
Part
No.
Part Name
* * *
Note: Items marked with * are pre-assembled.
4
ASSEMBLY INSTRUCTIONS
1. Rear Frame Assembly
Place the Seat Bolts (No. 8) in
the two holes in the seat.
Then place the seat on the frame,
ensure that the two bolts line up
with the holes in the frame.
Tighten the Seat Nuts (No.9) into
the bolts with the Larger Allen
Keys (No.5).
(WARNING: Make sure shaft sets are tightened and not loose)
8
8
9
9
5
5
2
ASSEMBLY INSTRUCTIONS
5
Line up the Front Fork as
shown & insert Steering
Bolt (No. 11) into the lower
hole from underneath.
Place a Plastic Stopper
(No. 6) over the Front Fork
Bolt (No. 11) then tighten
the Front Fork Nut (No. 10)
using the Smaller Allen Key
(No. 7).
Place the Plastic Stopper
(No. 6) over the 2nd Front
Fork Bolt then through the
upper hole and tighten the
Nut with the Smaller Allen
Key (No. 7).
2. Attaching the Front Fork to the Body
(WARNING: Make sure shaft sets are tightened and not loose)
11
7
11
6
7
11
6
6
10
ASSEMBLY INSTRUCTIONS
6
Align the wheel axle with either
the Top or Bottom slot of the
Fork.
Tighten the Wheel Bolt (No. 3.1)
on both sides and ensure the
Locking Washers (No. 3.2) fit into
the hole in the fork.
3. Attaching the Wheels to the Body
(WARNING: Make sure shaft sets are tightened and not loose)
3
3.1
2
3.2
3.3
4
3.1
3.2
4
When the wheels are in the bottom slot
ensure the Locking Washer (No. 3.2) is
located in the hole above the wheel slot.
If the Wheels are fitted in the top slot,
ensure the Locking Washer (No. 3.2) is
fitted in the hole below the wheel slot.
Please NOTE!
ASSEMBLY INSTRUCTIONS
7
The YBIKE Session has 2 wheel settings which adjust the height of the seat, as well as
the wheel base.
The Low setting has a seat height of 36cm.
The High setting has a seat height of 40cm.
Only Ride the YBIKE Session with both wheels in Low setting or, both
Wheels in the High setting.
Riding the YBIKE Session with the wheels in dierent positions can
result in damage to the product and can be dangerous to the rider.
Please NOTE!
4. Wheel Settings
Low - 36cm High - 40cm
ASSEMBLY INSTRUCTIONS
8
To change the wheel setting, turn the
YBIKE Session upside down so that it
rests on its handles & seat, on the
ground.
Then simply loosen the Wheel bolts
(No. 3.1) on both sides of the fork so
that the Locking Washer (No. 3.2) is
free from the locating hole on the fork
on both the back and front wheels.
Reposition the wheels to the desired
setting, and tighten the bolts ensuring
the Locking Washer (No. 3.2) is
aligned and fitted in position, as illustrated on pg. 6.
5. Adjusting the Wheel Settings
Visit
9
CHECK BEFORE RIDING
1. Check that all the bolt and shaft sets are tightened.
2. Check that the Handle bar is securely fastened and turns smoothly.
3. Check that the wheels can spin smoothly, are fully inated and each part is securely xed.
4. Finally after checking the above points, you can now start to ride.
WARNING!
This product must be assembled by an adult. Read the manufacturer’s instructions before using. Keep
the instructions safe for future reference. For children age group 2-5 years. Maximum weight 20kgs.
Avoid direct, high impact collisions into walls, sidewalks and other objects.
www.YBIKE.co.za
www.YBIKEUSA.com
Loading...