Canterbury Arbor
Assembly Manual
Canterbury Arbor
Assembly Manual
Thank you for your purchase of this arbor.
This manual is designed to simplify the assembly process. Please read through the entire manual before
starting!
Take a deep breath and get at it; the satisfaction and enjoyment of this arbor is only a few minutes away. Have
fun!
You have purchased a product that consists of bulky pieces. With your purchase, you assume full
responsibility to have the necessary manpower available to assemble the product. You also agree that any
damage that happens to the product during the entire construction process is your responsibility, and neither
the seller, nor the manufacturer, will be held liable for any such damage.
Square
Cordless
Drill
Tools Required for Job
Hammer
#2 Square
Drive Tip
(included)
25’ Tape
Measure
Star Drive Tip
(included)
4 Braces
Parts List
4 Posts
2- 2x6's for top
1 Hardware
Pack
7- 2x4's for top
Lattice Panels
2
4 Small Blocks
(not pictured)
Canterbury Arbor Assembly Manual
Step:1
Step:2
Position lattice panel between posts with
notched part of post facing out. Place small
blocks under each corner of lattice.
Step:3
Your first completed arbor side should look
like this. Repeat step two for second arbor
side.
Fasten lattice to posts using 2" screws. Use
pre-drilled holes in lattice. Measure from the
bottom of the post 10".
Step:4
Assemble arbor top. Position 2x6's on edge
with notches facing up. Fit notches on 2x4 into
the notches on the 2x6, then fasten with 3"
screws provided.
Step:5
The completed arbor top should look
like this.
4
Step:6
Turn arbor top upside down. Then fit together
the notch on the top of the post of a completed
arbor side and the notch on the arbor top
(circled in red). Repeat step on opposite side.
Canterbury Arbor Assembly Manual
Step:8Step:7
Use square to properly align post. Fasten 2x6 to
post using lag screws provided. Repeat this step at
each post.
Step:9
Fasten the brace to the arbor top at each corner.
Fasten a brace to each post. This stabilizes the
arbor. Continue using a square on this step.
Fasten the brace to the post first.
Step:10
Congratulations! Your arbor is now complete.
Step:11
Position arbor at desired location. Then
anchor each post to the ground using 4
anchors provided.
Patiova.com Info@Patiova.com 6649 N. Moscow Road Parkesburg, PA 19365 610-857-1359
5
Loading...