YaMeiShi Plastic and Electronic SW80 User Manual

SW80 Smart Watch User Manual

一、Functional Buttons

二、Power on/off

Power on： Power off：

Press button B & C together for 3 seconds Press button B & C together for 3 seconds

三、Functional Modes

Bluetooth
Day

Time

Incoming call alert
Incoming message alert
Remote control Photo-taking

Time Display Mode

Incoming message alert

Connect the watch and the

mobile phone via Bluetooth

and enable notification in the
“More”section of the App.

When the mobile phone

receives incoming message,

the notification will be pushed

to the watch, with beep sound

and blinking icon.

Manual time setting: Under time display mode, press and hold button D for 3 seconds to enter time setting,

then press button A and C to adjust time. Short press on button D to switch. Press button B to exit time

setting.

EL backlight: Press button A under any mode to light up EL backlight for 3 seconds.

Press button B to switch modes: 1. Date display mode; 2. Pedometer display mode; 3. Calorie

consumption display mode; 4. Walking distance display mode; 5. Alarm display mode; 6. Stopwatch mode;

7.Temperature display mode; 8. Barometric pressure display mode; 9. Ultraviolet index display mode.

Incoming call alert

Connect the watch and the

mobile phone via Bluetooth

and enable notification in the
“More”section of the App.

When the mobile phone

receives incoming call, the

notification will be pushed to

the watch, with beep sound and

blinking icon.

Remote control photo-taking

Connect the watch and the

mobile phone via Bluetooth,

open the mobile phone camera
through the “more”section

in the App. Press button B&C

(MODE+START button)

together shortly for remote

control photo-taking.

Date display mode:：

Under date display mode, long press and hold button

D for 3 seconds to enter date setting, and short press

button A and C to adjust digits. Short press button D

to switch and press button B to exit date setting.

Pedometer display mode：

Alarm display mode：

Long press button D for 3 seconds to set alarm, then

press button A and C to adjust digits; press button D

to switch and button B to save the alarm set. When

the alarm time set is on, the blinking alarm icon and

beep sound will remind the user. Press any button to

stop alarm.

Calorie consumption display mode;:

Walking distance display mode：

Under walking distance display mode, press button C

can switch between KM and Mile (default as KM)

Stopwatch mode：

After entering stopwatch mode, press button C to

start stopwatch. Press button D to stop stopwatch

and reset stopwatch to 0.