Natural Sound Stereo Cassette Deck
Platine à cassette stéréo de la série “Natural Sound”
“Natural Sound” Stereo-Doppelkassettengerät
Natural Sound stereokassettdäck
Registratore a doppia cassette stereo a suono naturale
Magnetófono estéreo de dos de sonido natural
Stereo-cassettedeck voor een “natuurlijk geluid”
BEDIENUNGSANLEITUNG
MANUAL DE INSTRUCCIONES
DIRECTION
RESETDIRECTION
RESET
STOP
DUBBING A # B
NORMAL
HIGH
! PLAY ⁄
STOP
MUTE/SEARCH
REC/PAUSE
EJECT
RECORD/PLAYBACK
DECK B
REC LEVEL
5
46
37
28
19
010
PHONES
OWNER’S MANUAL
MODE D'EMPLOI
BRUKSANVISNING
MANUALE DI ISTRUZIONI
GEBRUIKSAANWIJZING
Thank you for purchasing the YAMAHA KX-W592/KX-W492/KX-W392 stereo cassette deck.
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
1.This unit is a sophisticated stereo cassette deck. To
ensure proper operation for the best possible
performance, please read this manual carefully.
2.Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight or close to source of
heat. Also avoid locations subject to vibration and
excessive dust, heat, cold or moisture. Keep it away
from sources of hum such as transformers or motors.
3.Do not open the cabinet as this may result in damage
to the deck or electrical shock. If a foreign object
should get into the deck, contact your local dealer.
4.When removing the power plug from the wall outlet,
always pull directly on the plug; never pull the cord
itself.
5.Do not apply excessive force when operating
switches and knobs.
6.When moving the deck, be sure to first pull out the
power plug and remove all cords connecting the deck
to other equipments.
7.Do not attempt to clean this unit with chemical
solvents as this may damage the finish. Use a clean,
dry cloth.
etc.) to come near the record/playback head
assembly. Doing so may not only scratch or damage
the head’s mirror-smooth finish, but also change the
magnetic characteristics of the heads, causing a
deterioration in reproduction quality.
9.Although the record/playback head used in this unit
is a high quality head with outstanding reproduction
characteristics, it can become dirty through the use
of old tapes or from dust accumulation over time.
This can have a serious effect on reproduction
quality.
Clean the heads regularly with one of the commonly
available head cleaners or with cleaning solutions as
explained later in this manual.
10.Be sure to read the “Troubleshooting” section of this
manual for advice on common operating errors
before concluding that your unit is faulty.
11.Keep this manual in a safe place for future reference.
12.Voltage Selector (General Model only)
The voltage selector on the rear panel of this unit
must be set for your local mains voltage BEFORE
plugging in the AC mains supply.
Please check the copyright laws in your country to
record from records, compact discs, radio, etc.
Recording of copyright material may infringe copyright
laws.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION
The apparatus is not disconnected from the AC power
source as long as it is connected to the wall outlet, even if
the apparatus itself is turned off.
For U.K. customers
If the socket outlets in the home are not suitable for the plug
supplied with this appliance, it should be cut off and an
appropriate 3 pin plug fitted. For details, refer to the
instructions described below.
Note: The plug severed from the mains lead must be
destroyed, as a plug with bared flexible cord is hazardous if
engaged in a live socket outlet.
Special Instructions for U.K. Model
IMPORTANT
The wires in the mains lead are colored in accordance
with the following code:
Blue: NEUTRAL
Brown: LIVE
As the colors of the wires in the mains lead of this
apparatus may not correspond with the colored markings
indentifying the terminals in your plug, proceed as follows.
The wire which is colored BLUE must be connected the
terminal which is marked with the letter N or colored
BLACK. The wire which is colored BROWN must be
connected to the terminals which is marked with the letter
L or colored RED.
Making sure that neither core is connected to the earth
terminal of the three pin plug.
CAUTION (For Canada model)
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
THIS DIGITAL APPARATUS DOES NOT EXCEED THE
“CLASS B” LIMITS FOR RADIO NOISE EMISSIONS
FROM DIGITAL APPARATUS SET OUT IN THE RADIO
INTERFERENCE REGULATIONS OF THE CANADIAN
DEPARTMENT OF COMMUNICATIONS.
2
TABLE OF CONTENTS
FEATURES ......................................................................... 3
÷ Dual Recording allows you to make the same recording on
both decks simultaneously (KX-W592 only)
÷ Relay Playback from DECK A to DECK B
÷ Relay Recording from DECK A to DECK B (KX-W592
only)
÷ Selection Search
÷ Recording Mute Function
÷ Rec Return Operation
÷ Easy Dubbing Operation at Selectable Speed (Normal/
High)
÷ Peak Level Meters with Peak Hold Function
÷ Remote Control Capability with Optional Remote Control
Transmitter
ENGLISHFRANÇAISDEUTSCHSVENSKAITALIANOESPAÑOLDUTCH
Dolby noise reduction and HX Pro headroom extension
manufactured under license from Dolby Laboratories
Licensing Corporation, HX Pro originated by Bang &
Olufsen.
“DOLBY”, the double-D symbol
trademarks of Dolby Laboratories Licensing Corporation.
and “HX PRO” are
3
LINE IN-LINE OUT
REC
4
L
R
L
R
CONNECTIONS
PLAY
3
To an AC outlet
REAR PANEL CONNECTIONS
Make sure that power to both the deck and your amplifier/
receiver is turned off before making any connections.
TAPE PBREC OUT
Amplifier or receiver
÷ The White plug on the paired connecting cables
corresponds to the Left channel and the Red plug
corresponds to the Right channel. Make sure that the left
and right channel connections are properly made, and that
the plugs are inserted firmly.
÷ The LINE OUT/PLAY jacks on the deck should be
connected to the Tape PB (Playback/Input) jacks on your
amplifier/receiver, and the LINE IN/REC jacks on the deck
should be connected to the Rec Out (Recording/Output)
jacks on your amplifier/receiver.
÷ Connect the power cord to an AC wall outlet or to an AC
outlet on the rear panel of your amplifier/receiver (if
provided).
NOTES ON THIS MANUAL
In this manual, the main operation buttons of the front panel are indicated based on DECK B when the operation is common to
both DECKs A and B. Since the locations of the buttons of DECK B and DECK A are the same, you can easily find the desired
button even when operating DECK A. This manual covers three models. In most cases, however, only model KX-W592 is
shown in the example illustrations.
Main operation buttons of DECK B
Example: KX-W592
Main operation buttons of DECK A
NATURAL SOUND STEREO DOUBLE CASSETTE DECK KX-W592
Cassette Stabilizer
RECORD/PLAYBACK
DECK A
POWER
MODE
O / p / ∏ / RELAY
DOLBY NR
OFF/ B/ C
! PLAY ⁄
MUTE/SEARCH
STOP
DUBBING A # B
EJECT
NORMAL HIGH
RESETDIRECTION
REC/PAUSE
DIRECTION
RESET
! PLAY ⁄
MUTE/SEARCH
STOP
DSS
EFFECT
MODEDSS
REC/PAUSE
EJECT
PLAY TRIM
–+
0
Cassette Stabilizer
RECORD/PLAYBACK
0
11
22
33
44
L 5 5 R
REC LEVELBALANCE
37
28
19
DECK B
5
46
010
PHONES
4
PLAYBACK (Common to DECKs A and B)
Preparation for playback
÷ Turn on the POWER switch.
÷ Set your amplifier or receiver to cassette deck function mode.
Basic operation - To play back a cassette tape
ENGLISHFRANÇAISDEUTSCHSVENSKAITALIANOESPAÑOLDUTCH
Example: KX-W592
POWER
POWER ➠ ON
EJECT
NATURAL SOUND STEREO DOUBLE CASSETTE DECK KX-W592
Cassette Stabilizer
RECORD/PLAYBACK
DECK A
MODE
O / p / ∏ / RELAY
DOLBY NR
OFF/ B/ C
MUTE/SEARCH
34
Insert the cassette with the
exposed tape side facing
down. (The side facing you is
called the forward side and
the opposite side is called the
reverse side.) To close the
compartment, push in the
compartment door until it
locks shut.
!PLAY⁄
REC/PAUSE
STOP
DUBBING A # B
EJECT
NORMAL HIGH
RESET !
DIRECTION
RESETRESETDIRECTION
!PLAY⁄
MUTE/SEARCH
DSS
MODEDSS
STOP
EFFECT
56
REC/PAUSE
EJECT
PLAY TRIM
0
–+
STOP
2
231
Refer to the following description.
KX-W592 only
DSS
DSS
MODE
EFFECT
⁄
Cassette Stabilizer
RECORD/PLAYBACK
0
11
22
33
44
L 5 5 R
1
DECK B
REC LEVELBALANCE
PHONES
5
46
37
28
19
010
PHONES
OFF/ B/ C
Refer to the following
description.
DOLBY NR
46
MODE
“/[/”/
RELAY
5
Refer to the following
description.
To fast forward or rewind the tape
When the tape running indicator # is lit:
Pressing the ⁄ button fast forwards the tape while
pressing the ! button rewinds the tape.
When the tape running indicator @ is lit:
Pressing the ! button fast forwards the tape while
pressing the ⁄ button rewinds the tape.
DIRECTION
Select the tape running direction for DECK A
PLAY
or B. Each time this button is pressed, the
tape running direction changes between
forward (#) and reverse (@), and the
corresponding indicator lights on the display.
To stop playback
Press the STOP button. To remove the cassette tape, press
the EJECT button. The cassette compartment door opens.
To turn off the power, press the POWER button.
To set the counter reading to “0000”
Press the RESET button. Use the tape counter to aid in
locating a point on a tape (0000 to 9999).
5
DOLBY NR selector setting (in step 3)
Be sure to set the DOLBY NR selector according to the
system used for recording.
OFF: For a tape recorded with DOLBY NR OFF.
B: For a tape recorded with DOLBY B NR.
C: For a tape recorded with DOLBY C NR.
:Both sides of the tape are played back. After
playing, the deck stops at the end of the tape.
(When the tape running direction is set to ¤, only
the reverse side is played.)
: Both sides of the tape are repeatedly played back
(up to 8 times).
REVERSE MODE selector setting (in step 4)
The auto reverse function allows the tape running direction
be reversed automatically. Select an auto reverse mode
(
(
,, or
).
) or manual reverse mode
RELAY
: When playback or fast forwarding (or rewinding) of
one side of a tape is finished, the deck stops at the
end of the tape.
Display during playback
The A or B indicator shown in
the display represents the
last deck operated.
Tape counter
KX-W592
Tape running direction
indicator (DECK A)
¤
RECDUBHIGHRECB C
HALL
RELAY
are played back sequentially. (See “RELAY
PLAYBACK” on page 8.)
DSS PRESET
PROGRAM indicators
A
‹
DISCO CHURCH JAZZ
RELAY
NORM
: Cassette tapes loaded in DECKs A and B
Tape running direction
indicator (DECK B)
Tape counter
¤
B
‹
L
–
30 dB
20151086 420246
+
R
Peak level meters
Indicate the peaks of the signal levels during recording and playback over a –30 dB to +6 dB range. There are separate meters for each left
and right channel. These level meters have a peak hold function which holds the peak level for about 1.5 seconds.
KX-W492/
KX-W392
¤
A
‹
DUBHIGHRECB C
NORM
RELAY
¤
B
‹
Displayed indicators
represent the same
functions as shown above.
To adjust the volume level
Use the volume control of the amplifier or receiver.
L
–
30 dB
20151086 420246
+
R
Note
Never press the EJECT button during playback.
To use headphones
Insert the headphones plug into the PHONES jack. Since
the sound is also heard from the speakers, operate the
amplifier to cut off the sound from the speakers for private
listening.
6
Example: KX-W592
MUTE/SEARCH
RESET
!⁄
NATURAL SOUND STEREO DOUBLE CASSETTE DECK KX-W592
DIRECTION
RESETRESETDIRECTION
POWER
Cassette Stabilizer
RECORD/PLAYBACK
DECK A
MODE
O / p / ∏ / RELAY
DOLBY NR
OFF/ B/ C
! PLAY ⁄
MUTE/SEARCH
STOP
DUBBING A # B
EJECT
NORMAL HIGH
REC/PAUSE
! PLAY ⁄
MUTE/SEARCH
STOP
DSS
EFFECT
MODEDSS
REC/PAUSE
EJECT
PLAY TRIM
–+
0
Cassette Stabilizer
RECORD/PLAYBACK
0
11
22
33
44
L 5 5 R
REC LEVELBALANCE
37
28
19
010
DECK B
5
46
PHONES
SELECTION SEARCH - To play back a desired selection by searching for the beginning of the selection
To search for the next selection
When the # tape running indicator is lit:
⁄
Press
simultaneously.
MUTE/SEARCH
To search for the beginning of the current selection
When the # tape running indicator is lit:
When the @ tape running indicator is lit:
!
Press
simultaneously.
MUTE/SEARCH
When the @ tape running indicator is lit:
ENGLISHFRANÇAISDEUTSCHSVENSKAITALIANOESPAÑOLDUTCH
!
MUTE/SEARCH
Press
simultaneously.
⁄
MUTE/SEARCH
Press
simultaneously.
To search for the selection located before the current selection
÷ Operate the following buttons when the beginning of the current selection is being played.
When the # tape running indicator is lit:
!
Press
simultaneously.
MUTE/SEARCH
When the @ tape running indicator is lit:
⁄
Press
simultaneously.
MUTE/SEARCH
Notes
÷ The blank interval between selections must be at least 4 seconds long.
÷ Selection search may not operate properly with tapes recorded at a low recording level or which have excessive noise.
7
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.