YachtSafe W100 User Manual

N 30 32.89’
E 114 18.04’

YachtSafe Manual

Vibration sensor

W100 Vibration sensor

Version 2018 l VETEL AB l [e-mail] l www.yachtsafe.se l Gothenburg l Sweden

Installation of Vibration sensor

Mount the battery

Release the screws with a cross-headed screwdriver to be
able to open up the product and mount the battery. The
LED lamp is ashing if the battery is OK.

Technical specications

Measurements:

Battery lifetime:

Battery capacity:

Distance range
(free sight):

Temperature range:

Sealing:

Additions or adjustments to this manual can be found at
www.yachtsafe.se under the Manuals tab.

72 x 35 x 23 mm

up to 2 years

1000 mAh

approx 150 m

-30 to 70°C

IP67

iOS instructions

Connect the alarm accessory
to the G32 system via the app
for iOS or Android:

IMAGE 1 Select Alarm accessories & Relay

IMAGE 2 Add & congure accessories

IMAGE 3 iOS: New accessory

Android: Choose alarm accessory

IMAGE 4 Choose the accessory to connect.

Enter a name for the accessory and
then press Connect and follow the
instructions.

iOS: After connection of the

accessory, go to the tab Alarm ac­cessories & Relay, press Update in
the top right. Choose to activate/
Inactivate the alarm accessory
by the button Edit in the top left.
Choose your setttings and press
Save.

Android: After connection of the

Alarm Accessory, go to the tab
Alarm accessories & Relay, press
Update. Choose to activate/inac­tivate the alarm accessory by the
symbol in the top right (press
Edit). Choose your settings and
press Save.

Android instructions

IMAGE 1 IMAGE 2 IMAGE 3 IMAGE 4

Verifying the magnetic alarm connection?

When you have activated, the small LED-light on the accessorie should blink
rappidly when the connection is OK. If connection failed it will only turn the LED­light on once for aprox 1-2 sec. If you do not get any response in the app, try again.
When activation is successfull you are ready to mount the magnet alarm. Please
wait approx 2 minutes before you connect another alarm accessory to the G32
system.

Mounting

Vibrations and chocks make the vibration sensor send an alarm. Note that after the
alarm is activated the sensor must be still for 10 seconds before it sends an alarm.
The vibration sensor can be mounted on metal materials with help of the magnetic
feet (Accessory). It’s also possible to mount it with the help of cable ties around
cables and other objects. The vibration sensor is waterproof and made for outdoor
environment. The signal from the sensor part to the alarm unit will pass through
walls and a big variety of materials. However, check the signal before mounting. Af­ter the accessory has been connected to the alarm you are able to push the button
on the circuit card fast. If the LED light on the circuit board is ashing this means
that the distance range is enough. You will receive alarm directly in your phone if
the battery in the accessory has to be changed.

To change the level of sensitivity the sensor needs to be opened up. There is a
switch on the circuit card with three dierent positions (Low, medium, high) that
you can choose from.

Low:

Medium:

High:

1 2 3

Connection
button