N 30 32.89’
E 114 18.04’
Version 2018 l VETEL AB l info@vetel.se l www.yachtsafe.se l Gothenburg l Sweden
YachtSafe Manual
Temperature monitor
W050 Temperature monitor
Mount the batteries
Use cross-headed screwdriver to release the screws and
be able to open up the product. Mount the battery / batteries. The LED lamp is ashing if the battery / batteries
are ok.
Installation of Temperature monitor
Technical specications
Measurements:
Battery lifetime:
Type of battery:
Battery capacity:
Distance range
(free sight):
Temperature range:
Sealing:
60 x 35 x 20 mm
up to 6 years
CR2477
1000 mAh
approx 150 m
-30 till 70°C
IP54
Additions or adjustments to this manual can be found at
www.yachtsafe.se under the Manuals tab.
IMAGE 1 IMAGE 2 IMAGE 3 IMAGE 4
Connect the alarm accessory
to the G32 system via the app
for iOS or Android:
IMAGE 1 Select Alarm accessories & Relay
IMAGE 2 Add & congure accessories
IMAGE 3 iOS: New accessory
Android: Choose alarm accessory
IMAGE 4 Choose the accessory to connect.
Enter a name for the accessory and
then press Connect and follow the
instructions.
iOS: After connection of the
accessory, go to the tab Alarm accessories & Relay, press Update in
the top right. Choose to activate/
Inactivate the alarm accessory
by the button Edit in the top left.
Choose your setttings and press
Save.
Android: After connection of the
Alarm Accessory, go to the tab
Alarm accessories & Relay, press
Update. Choose to activate/inactivate the alarm accessory by the
symbol in the top right (press
Edit). Choose your settings and
press Save.
iOS instructions
Android instructions
Verifying the magnetic alarm connection?
When you have activated, the small LED-light on the accessorie should blink
rappidly when the connection is OK. If connection failed it will only turn the LEDlight on once for aprox 1-2 sec. If you do not get any response in the app, try again.
When activation is successfull you are ready to mount the magnet alarm. Please
wait approx 2 minutes before you connect another alarm accessory to the G32
system.
Mounting
The temperature monitor sends an alarm when the temperature passes the alarm
limits chosen in your app. The temperature monitor has holes to be able to mount
this part with screws. It can also be mounted with the help of tape, glue or burdock. Place the sensor at the actual spot from which you want to receive temperature information. The signal from the sensor part to the alarm unit will pass through
walls and a big variety of materials. However, check the signal before mounting.
After the accessory has been connected to the alarm you are able to push the
button on the circuit card fast. If the LED light on the circuit board is ashing this
means that the distance range is enough. You will receive an alarm directly in your
phone if the battery in the accessory has to be changed.
Loading...