XL-ET1035B
V.35 – Ethernet bridge
User’s Guide
XL-ET1035B User’s Guide
XL-ET1035B Ethernet network bridge is a equipment that through V.35 implement Ethernet
connection. Adopt DTE interface style, supply timepiece from DCE equipment, support rate reach
10Mbps. Ethernet interface adopt 10Base-T standard, support 10Mbps full duplex and half duplex
protocol.
• WAN interface V.35
• Interface style DTE
• Line code NRZ
• Data rate 0~10Mbps
• Ethernet interface 10Base-T, full and half duplex, IEEE 802.3
• MAC address table for 10k MAC address
• Filtrate and convert up to 15000 pps
• Support 256 frame data slow memory
• Support timepiece: DCE equipment timepiece
• Power consumption: 1,5W (220V AC, 5V DC)
• Temperature: -40 to +85 oC
• Humidity: 10% to 90% non-condensing
• Dimension: 220 x 150 x 40 mm
• Weight: 240g
2
XL-ET1035B User’s Guide
Front panel:
Indicator Description
PWR
LINK
WTX
WRX
LTX
LRX
COLL
ERR
Rear Panel:
Power indicator. Brightness when powered.
Ethernet connection established.
V.35 port sending data.
V.35 port receiving data.
Ethernet port sending data.
Ethernet port receiving data.
Ethernet port detected collision.
Equipment alarm indication.
Port Description
10Base-T LAN port, Ethernet standard 10Base-T, RJ-45 connector.
SW1 Switch panel, configuring device parameters.
V.35 DTE interface V.35 interface, connector DB-25. Connect supplied V.35 cable
here.
POWER Power supply port
3
XL-ET1035B User’s Guide
DIP switch SW1 settings:
Setting device parameters. Please leave in default state if you do not know what their purposes
are.
Ethernet working mode setup:
Switch No. 1: OFF: Force full duplex 10Base-T ON: Force half duplex 10Base-T
Data compression setup:
Switch No. 2: OFF: Compression enabled ON: Compression disabled.
V.35 interface receive timepiece phases adjust:
Switch No. 3: OFF: Cut timepiece ON: receive data on rising edge of RCLK
Switch No. 4: OFF: Cut timepiece ON: receive data on lowering edge of RCLK
Switch No. 5: OFF: Cut timepiece ON: transmit data on rising edge of TCLK
Switch No. 6: OFF: Cut timepiece ON: transmit data on lowering edge of TCLK
DB-25 connector description:
Pin Description I/O
1 GND
2 TDA Input
3 RDA Output
4 NC
5 CTS Output
6 DSR Output
7 GND
8 DCD Output
9 RCB Output
10 NC
11 XTCB Input
12 TCB Output
13 NC
14 TDB Input
15 TCA Output
16 RDB Output
17 RCA Output
18 NC
19 NC
20 NC
21 NC
22 NC
23 NC
24 XTCA Input
25 NC
4
Loading...