
XL-EHDMI11-TR
The HDMI CAT5 Extender is using only one cost effective CAT5E/6 cable to extend your HDTV
display up to 70 meters at 1080i and 50 meters at 1080p. It is equipped with HDMI
connectors and also supports DVI equipment with allowing used with a HDMI to DVI adapter.
It provides an easy and flexible cabling solution for integrating home theater components.
HDMI CAT5 Extender Over Single cable Series
HDMI CAT5 Extender – Single CAT5 cable 50 Meters
Extends HDMI signal over one CAT5/5e/6 cable.
HDMI 1.3 compliant.
Transmission range up to 50M at 1080i, 30M at 1080p resolution.
Extend the transmission distance up to 50M at 1080i / 720p.
Extend the transmission distance up to 30M at 1080p.
Panel view & Function:

Use the default EDID.
Use the backup TV EDID. ( If backup TV EDID is not correct, it will auto
select the first default EDID)
Select the first default EDID: support 1080i / LPCM 2 Channel.
Select the second default EDID: support 1080p / LPCM 5.1 Channel.
Backup EDID ( The Dip Switch 1 must at
↓
position, then to start backup).
Reserve (Dip switch 4 , do not move to
↓
)
Transmitter Unit LED Indication:
BLUE ON - Power on
Flash - Under backup TV EDID, wait TV accept.
Flash one time - TV EDID backup completed
Flash two times - TV EDID backup failed, incorrect EDID.
Flash three times - TV EDID backup failed, EDID checksum error
RJ45 Connector LED:
GREEN ON Sending power or video to receiver unit
YELLOW ON No data input or unsupported video format
Dip Switch function:
o After complete Dip Switch setting, power must be reset ( unplug and plug) to
activate the new EDID.
Receiver Unit LED Indication:
GREEN ON Sending power or video to receiver unit
YELLOW ON No data input or unsupported video format
Cable:
Link cable using high quality CAT5e UTP or CAT6 UTP cable.
CAT6 cable is recommend based on distance over 30 meters.
Using FTP (STP) cable could have interference rejection, but may cause distance shorter.

Transmission Distance:
480i/p, 720p, 1080i/p @ 24/50/60Hz
CAT5e 50M @1080i, CAT5e 30M @1080p
Input TMDS Signal 1.2 volts peak to peak
HDMI 19 pin type female connector
RJ-45 Shielded with 2 indication LEDS
5V DC 2AMP regulated (External)
Operation: 0 to 55℃, Storage: -20 TO 85℃, Humidity: up to 95%
The transmission distance will be affected from different HDMI equipment and cable
quality. Lower resolution and good quality cable could extend longer distance up to 100
meters.
RJ45 Define:
Video Link (use TIA/EIA-568-B)
Caution:
1. The cabling must away from any equipment with electromagnetic wave, such
as microwave ovens, mobile phones, radio equipment, power lines.
2. Our HDMI CAT5 Extender not networking product, please do not connect with
Specification:
any Ethernet to avoid any damage.