EBF-211-Z3735F-2-32
Mini PC
Quick user's manual
Product Spec
• Processor/Memory/Storage
• Intel® Atom™ BayTrail
• Z3735F
• Up to 2 GB RAM
• 32/64/128/256GB eMMC Flash
• Connectivity
• Max 128G Micro/TF card reader
• USB2.0 * 3 HDMI * 1 VGA * 1
• earphone
• microphone(combo)
• Power * 1 Bicolors * 1
• 5V/3A DC-in ,3.5mm
• WIFI 802.11b/g/n+BT 4.0
MINI PC Confidential
MINI PC Confidential
POWER UP YOUR DEVICE
Power button
· Power on/off
· Restart
· Sleep
MINI PC Confidential
GET TO KNOW YOUR DEVICE
113.9
115.9
19
MINI PC Confidential
GET TO KNOW YOUR DEVICE
USB 2.0
RJ45
DCIN
VGA
TF CARD
HDMI
Audio
I/O
A
C
Power button
Connect adpater and press power button.
Press this button in DOS interface will close the computer.
If the computer crashes, press power button for 5 seconds will
close the it.
Notice: Pressing power button for 5 seconds to close computer will
cause damage to system, please use this function with caution.
HDMI
HDMI of this computer is 1.4 standard.
HDMI interface can transmit sound and image simultaneously if
your monitor is with sound output.
If HDMI interface is unable to transmit sound and image
simultaneously, set tup the system as follows:
Select single sound output in the sound output setup
After that move, restart the playing content or the computer.
s
B
VGA
VGA interface supports up to 2560*1600, but this is also up to
monitor.
If the monitor do not show when the computer is booted, check if
the VGA is connected or not. Tighten the screw.
5V/3A DC_IN
Please use the adapter we send along. Any damage caused by
adapters of other souce will be out of our reponsibility.
Notice: Please do not plug the adapter wire if the computer is
booted, for it will cause damage to hard disk and system.
AUDIO OUT
This interface is standard 3.5mm, and applies to all sound.
TF CARD
D
J
G
A
C
D
E
F
G
H
I
J
B
E
Network card is open by default.
USB
3*USB2.0
Please use these interfaces with care
FIH
Rj45
Press DELETE key for some time to enter BIOS
Change boot time（Hour,minute and second form up side down）
After that, Press F10 and click YES to save . The computer will restart.
(Notice:↑↓← →keys on the keyboard can change direction)
Press DELETE to enter to BIOS
Click South Bridge under Chipset, and press [Enter]
Click Restore AC Power Loss, and pres [Enter] to change Power off to Power
on
Chipset
North Bridge
South Bridge
Save conf iguration and reset?
Save & reset
Yes NO
Chipset
Restore AC Power Loss
Power off
Power on
Last State
Addio Controller [ Enabled ]
PCI Express Root Port 2 ( LAN ) [ Enabled ]
PCI Express Root Port 4 ( PCIE ) [ Enabled ]
Make on LAN
Restore AC Power LOSS [ Power off ]
Chipset
North Bridge
South Bridge
Boot after connected to power
Timing Boot
RTC Power On Funtion
Advanced
[Disabled]
Enable or disable System wake on alarm
event. When enabled, System will wake
on the hr :: min :: sec specified
RTC Power On Funtion
Disabled
Enabled
BIOS Information
BIOS Vendar
BIOS Version
Build Date and Time
CPU Information
Intel(R) Celeron(R) CPU 1037U 1.80GHz
Memory Information
Total Memory
Memory Frequency
Intel SB Name
Stepping
ME FW Version
ME Firmware SKU
System Date
System Time
American Megatreds
CR20T103
04/29/2014 16∶37∶45
4096 MB (DDR3)
1333 Mhz
NM70
04/C1
8.1.40.1416
1.5MB
[Tue 07/22/2014]
[14∶12∶29]
Set the Date. Use Tab to switch
between Date elements.
→←：Select Screen
¤￠：Select Item
Enter：Select
＋/－：Change Opt.
F1：General Help
F2：Previous Values
F9：Optimized Deafults
F10：Save & Exit
ESC：Exit
Advanced
Chipset
Boot
Security
Save & Exit
Main
RTC Power On Funtion
RTC Power On Hour
RTC Power On Minute
RTC Power On Second
[Enabled]
0
0
0
Enable or disable System wake on alarm
event. When enabled, System will wake
on the hr :: min :: sec specified
Advanced
Legacy OpROM Support
Launch LAN PXE OpROM
ACPI Settings
CPU Configuration
SATA Configuration
Intel(R) Rapid Start Technology
USB Configuration
IT8772E_B HW Monitor
CPU PPM Configuration
APM Configuration
[Enabled]
Save & reset
Save configuration and reset
Yes
No
Advanced
Main
BIOS Information
BIOS Vendor American Megatrends
BIOS Version CR20T103
Build Date and Time 04/29/2014 16:37:45
CPU information
intel(R) Celeron(R) CPU 1037U 1.80GHz
Memory informat ion
Total Memory 4096 MB (DDR3)
Memory Frequency 1333 Mhz
intel SB Name NM70
Stepping 04/C1
ME FW Version 8.1.40.1416
ME Firmware SKU 1.5MB
[ Tue /22/2014]
System Time [ 14:12:29 ]
System Date 07
Advanced
Click APM Configuration under Advance and press [Enter]
Change Disabled to Enabled by pressing [Enter]
Legacy OpROM Support
Launch LAN PXE OpROM
ACPI Settings
[Disabled]
Advanced
APM Configuration
CPU Configuration
SATA Configuration
Intel(R) Rapid Start Technology
USB Configuration
IT8772E_B HW Monitor
CPU PPM Configuration
(Notice:↑↓← →keys on the keyboard can change direction)
After that, Press F10 and click YES to save . The computer will restart.
Loading...