XPiQ inc IFC400-56B, IFC400-55B, IFC400-50B, IFC400-51B Datasheet
Active PFC - Meets EN61000-3-2, -3
•
5 Isolated & Regulated Outputs
•
3 Outputs have Current Sharing
& Oring Diodes
•
OVP, OCP, OTP, DC OK & Remote Sense
•
Dedicated 12 V/250 mA Fan Output
•
International Safety Approvals
•
•
Input
AC Input Voltage • 90-264 VAC
Input Frequency • 47-63 Hz
DC Input Voltage • 170-370 VDC
Power Factor • 0.98 typical
Inrush Current • 43 A at 115 VAC, 86 A at 230 VAC
Input Current • 7.1 A (rms) at 115 VAC,
3.2 A (rms) at 230 VAC
Output
Output Voltage • See Table
Output Power • 400 Watts
Output Voltage • ±10% on V1, V2 and V3
Adjustment
Minimum Load • 5 A - V1, 1 A - V2, 0 A - V3, V4 & V5
Line Regulation • ±0.5% from low line to high line
Load Regulation • ±2% for V1 and V2, ±3% for V3
±4% for V4 and V5
Ripple and Noise • ±2% maximum
Transient Response • 4% max deviation, 500 µs recovery
time for a 25% load change
Temperature • 0.04%/°C
Coefficient
Hold up Time • 12 ms minimum at 115 VAC
Overvoltage • 112% to 132% for V1 only,
Protection recycle input to reset
Overcurrent • All outputs protected to short circuit
Protection conditions
Overtemperature • Provided
Protection
Remote Sense • V1 - 0.3 V min, V2 - 0.2 V min,
V3 - 0.5 V min
Current Share • Single wire current sharing V1, V2 & V3
General
Efficiency • 70% typical
Power Density • 4.15 W/in
3
Leakage Current • 0.46 mA at 115 VAC,
Maximum 0.80 mA at 230 VAC
Switching Frequency • 94 kHz, ±5 kHz
MTBF • 100,000 hrs min to MIL-HDBK-217F
Isolation Voltage • 3000 VAC Input to Output
1500 VAC Input to Ground
500 VAC Output to Ground
Signals • DC OK
Size • 5.00” x 11.00” x 1.75”
Weight • 1.7 kgs (3.74 Lbs.) approx.
Environmental
Operating • 0 °C to +70 °C with derating
Temperature
Cooling • 45.2 CFM required for full power from
0 °C to +50 °C, derate linearly from
100% load at +50 °C to 50% load
at +70 °C
Humidity • 5-95% RH, non-condensing
Storage • -40 °C to +85 °C
Temperature
EMC & Safety
Safety Approvals • UL1950, CSA C22.2 No 60950,
EN60950 CE Mark LVD
EMI/EMC • EN61000-3-2, -3 EN55022 & FCC 20780
Class B conducted, Class A radiated
Immunity and Surge • EN55024 (EN61000-4-2, -3, -4, -5,
-6, -8, 11)
400 Watts
IFC400 Series
AC/DC U-Channel
Specification
•
Intelligent Design Quality Product
XPiQ inc.
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA
www.XPiQ.com
IFC 400.qxd 6/6/03 3:11 pm Page 1
Mechanical Details
Notes
1. All outputs are isolated and have individual return leads. Outputs can be either positive or negative.
2. Outputs V1, V2 and V3 include single wire current sharing and oring diodes.
3. Output V1 requires 5 A minimum load.
4. Output V2 requires 1 A minimum load.
5. Peak current for output V3 is 12 A for 12V or 9.6 A for 15 V.
6. 45.2 CFM forced air cooling is required for 400 W output.
•
Notes:
1. Dimensions shown are in inch (mm).
2. Tolerance is 0.02 (0.5) maximum.
3. P1 input connector is Beau Inc. P/N 72-5-03C, screws are #6-32 on 0.375 inch (9.53 mm) centers.
4. P4 Output connector is Dinkle P/N 166-06P.
5. P8 is for DC fan rated 12V/0.25 A.
6. P8 and P9 Connectors mate with Molex housing 22-01-1023 and Molex 40445 series crimp terminal.
7. Main output studs P2/P3 use M5*0.8 screws.
8. Weight: 1.70 kgs (3.74 lbs.) approx.
Note:
For each Sub-board, Pin 1 is
located at the top of the
connector.
DC OK Signal Spec
TTL logic high for normal operation, TTL logic low upon loss of input power.
This signal appears at least 1 ms prior to the +5.1 V output dropping 5% below its nominal value.
The signal also provides a minimum delay of 100 ms after the +5.1 V output is within regulation.
PIN CONNECTIONS
P1
Pin Function
1 Live
2 Neutral
3 GND
P2
Pin Function
1 V1+
P3
Pin Function
1 V1 Return
P4
Pin Function
1 V5+
2 V5 Return
3 V4+
4 V4 Return
5 V3+
6 V3 Return
P5
Pin Function
1 V2+
2 V2 Return
P8
Pin Function
1 Fan (+12 V)
2 Fan Return
P9
Pin Function
1 Return
2 DC OK
PIN CONNECTIONS
CB4 Sub-board
(for V1)
Pin Function
P4-1 + Sense
P4-1 - Sense
P4-1 Current Share
CB6 Sub-board
(for V3)
P3-1 + Sense
P3-2 - Sense
P3-3 Current Share
CB7 Sub-board
(for V2)
P3-1 + Sense
P3-2 - Sense
P3-3 Current Share
Output Power Output Output Output Total Model
Maximum Number Voltage Current Regulation Number
V1 5.1 V 40 A 2%
V2 3.3 V 20 A 2%
400 W V3 12.0 V 9 A 3% IFC400-50B
V4 12.0 V 6 A 4%
V5 5.0 V 6 A 4%
V1 5.1 V 40 A 2%
V2 3.3 V 20 A 2%
400 W V3 15.0 V 8 A 3% IFC400-51B
V4 15.0 V 5 A 4%
V5 24.0 V 4 A 4%
V1 5.1 V 40 A 2%
V2 3.3 V 20 A 2%
400 W V3 12.0 V 9 A 3% IFC400-55B
V4 12.0 V 6 A 4%
V5 24.0 V 4 A 4%
V1 5.1 V 40 A 2%
V2 3.3 V 20 A 2%
400 W V3 15.0 V 8 A 3% IFC400-56B
V4 15.0 V 5 A 4%
V5 5.0 V 6 A 4%
OUTPUT VOLTAGE & CURRENT RATINGS IFC400
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA
www.XPiQ.com
IFC 400.qxd 6/6/03 3:11 pm Page 2
Loading...