XPiQ inc IFC125-42-3, IFC125-14, IFC125-40-1 Datasheet
Active PFC - Meets EN61000-3-2, -3
•
Small Size 3.0” x 5.0” x 1.25”
•
Single, Triple & Quad Outputs
•
Overvoltage & Overcurrent Protection
•
Power Fail Detect
•
International Safety Approvals
•
•
Input
AC Input Voltage • 90-264 VAC
Input Frequency • 47-63 Hz
Power Factor • 0.98 typical
Inrush Current • 24 A max at 100 VAC
Input Current • 0.8 A max at 240 VAC
1.8 A max at 100 VAC
Output
Output Voltage • See Table
Output Power • 125 Watts
Minimum Load • 5 W minimum load on any output
or combination of outputs required
to maintain regulation
Line/Load Regulation • See Table
Ripple and Noise • ±2% pk-pk maximum
> = 5 V out ±1% maximum
Transient Response • 5% max deviation, recovering
to a 1% of final value in less than
500 µs after a 25% load change
Temperature • 0.04%/°C maximum
Coefficient
Hold up Time • >28 ms minimum at full load
Overvoltage • V1 & V2: 113% to 148% recycle input
Protection to reset
Overcurrent • All outputs 115% to 135% with
Protection auto recovery
Remote Sense • V1 only compensates for 0.5 V drop
Not Available on IFC125-31
General
Efficiency • 83% typical
Power Density • 6.66 W/in
3
MTBF • >220,000 hours per Bellcore
Isolation Voltage • 3000 VAC Input to Output
1500 VAC Input to Ground
500 VAC Output to Ground
Signals • Power Good - On = Logic Hi
Size • 5.00” x 3.00” x 1.25”
Weight • 312 grams approx.
Environmental
Operating • -25 °C to +70 °C derate linearly from
Temperature 100% load at +70 °C to 50% load
at +50 °C
Cooling • 5 CFM forced air required for 125 W
Humidity • 5-95% RH, non-condensing
Storage Temperature • -40 °C to +85 °C
EMC & Safety
Safety Approvals • UL60950, CSA22.2: 60950 per cUL,
EN60950, CE mark LVD
EMI/EMC • Meets EN61000-3-2, -3
EN55022/CISPR22 Class B and FCC
Class B conducted
125 Watts
IFC125 Series
AC/DC Open Frame
Specification
•
Intelligent Design Quality Product
XPiQ inc.
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA
www.XPiQ.com
OUTPUT VOLTAGE & CURRENT RATINGS IFC125
Mechanical Details
Notes
1. Total regulation includes tolerance, line regulation and load regulation.
2. Maximum output power not to exceed 125 W with 5 CFM forced air or 70 W with convection cooling.
3. For models IFC125-40-1 and -42-3, a maximum of 80 W combined +2.5 V or +3.3 V and +5 V outputs with 5 CFM of forced air cooling
or 40 W with convection cooling.
4. 5 W minimum load required to maintain regulation.
•
Output 1 Output 2 Output 3 Output 4 Model
Vnom Imax Reg
(1)
Vnom Imax Reg
(1)
Vnom Imax Reg
(1)
Vnom Imax Reg
(1)
Number
24.0 V 5.2 A ±3% 12.0 V 0.5 A ±5% IFC125-14
5.0 V 16.5 A ±4% 12.0 V 5.0 A ±5% -12.0 V 0.5 A ±5% IFC125-31
2.5 V 12.5 A ±2% 5.0 V 15.0 A ±4% 12.0 V 5.0 A ±5% -12.0 V 0.5 A ±5% IFC125-40-1
3.3 V 10.0 A ±2% 5.0 V 15.0 A ±4% 12.0 V 5.0 A ±5% -12.0 V 0.5 A ±5% IFC125-42-3
Pin 1 Neutral
Pin 2 Missing Pin
Pin 3 Line
J1-AC Input Connector
All models.
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA
www.XPiQ.com
Mechanical Drawing for IFC125-31, -40-1 and -42-3 only. See next page for IFC125-14
J2 - DC Output Connector
IFC125-31 IFC125-40-1 IFC125-42-3
Pin 14 +5 VDC +5 VDC +5 VDC
Pin 13 +5 VDC +5 VDC +5 VDC
Pin 12 +5 VDC +5 VDC +5 VDC
Pin 11 +5 VDC +5 VDC +5 VDC
Pin 10 DC GND DC GND DC GND
Pin 9 DC GND DC GND DC GND
Pin 8 DC GND DC GND DC GND
Pin 7 DC GND DC GND DC GND
Pin 6 DC GND DC GND DC GND
Pin 5 Not Used. +2.5 VDC +3.3 VDC
Pin 4 Not Used. +2.5 VDC +3.3 VDC
Pin 3 Not Used +2.5 VDC +3.3 VDC
Pin 2 +12 VDC +12 VDC +12 VDC
Pin 1 -12 VDC -12 VDC -12 VDC
IFC125-31 IFC125-40-1 IFC125-42-3
Pin 1 0V Sense 0V Sense 0V Sense
Pin 2 Not Used +2.5 V Sense +3.3 V Sense
Pin 3 Power Good Power Good Power Good
J3-Remote Sense
& Power Good Connector
NOTE: J3-1 must be connected
to DC GND at output or at load.
J3-2 must be connected to Output
1 at the output or load
IFC125-31 IFC125-42-3
&-40-1
J1 Housing 09-50-8031 90-50-8033
Pins 08-52-0113 08-52-0113
J2 Housing 09-50-8141 09-50-8143
Pins 08-52-0113 08-52-0113
J3 Housing 22-01-3037 22-01-3037
Pins 08-50-0114 08-50-0114
Mating Connectors
with Molex part numbers
Loading...