7
4
6
10
Phone model:
S0311WWR
- UMTS 850/1900
- GSM 850/900/1800/1900
User Manual
DISCOVER YOUR PHONE
2
1
WHAT’S INCLUDED
+1 Spareone 3G Phone
+1 Quick Start Guide
+2 Batteries
+1 Speed Dial Insert
+1 Nano SIM Card Adapter
+1 iPhone Pin
1) SpareOne 3G
3
Water resistant up to one meter
for 30 minutes water resistant
2) Earpiece
3) Two AA Energizer
Ultimate Lithium Batteries
Compatible with Alkaline,
Lithium, and NIMH batteries.
5
4) Battery LED
100%-40% life left [ blinks green ]
11
9
12
7
8
13
40%-20% life left [ blinks red ]
Change battery [ blinks fast red ]
5) Antenna/Network LED
Signal Found [ blinks blue ]
Searching [ blinks blue and red ]
No network [ blinks red ]
6) Volume Button
There are three volume levels.
Hold the volume button to adjust.
How to use panic siren
Hold the volume button for 7 seconds.
7) Keypad
Speed dial ( Glow in the dark)
a) You can set 9 speed dial numbers
in M1-M9. To set up a speed dial,
enter a phone number by using keys
0-9 and then hold one key M1-M9
for 5 seconds to save number.
[ Validation Beep ]
b) To call M1-M9, simply press the
desired number for 2 seconds.
[ Audible Feedback ]
8) Microphone
9) Torchlight Button
How to use the torchlight
Press and release the torchlight button.
Hold the torchlight button for 3 seconds.
[ Light stays on ]
Hold the torchlight button for 10 seconds.
[ SOS signal ashes ]
10) Call Button
How to answer a call
When the phone rings,
press the call button to answer.
How to make a call
Enter the phone number using the
keypad and press the call button.
How to redial
To redial the last incoming or outgoing
call, press the call button two times.
[ Keypad number sounds ]
How to accept /end a second call
In the event of a second incoming call,
press the call button to accept the
second call. Press the call button again
to switch to the rst call or press the
power button to nish the second call.
[ Beep ]
11) Emergency Button
Hold the emergency button for 2 seconds.
[ Audible Feedback ]
The emergency button is set up to call
a pre-set emergency number.
[ Even with no SIM card, you can always
call emergency services by pressing
the button or by directly dialing
9-1-1, 9-9-9, 1-1-2... ]
How to program
1) Press and release the power button.
2) Dial the sequence [ #-1-2-3-# ].
3) Enter the number to dial when the
emergency button is pressed.
4) Hold the emergency button for
2 seconds to save the programmed
number.
[ Beep ]
12) Power Button
How to power on/o
Press the power button for 2 seconds.
[ Audible Feedback ]
How to end a call
Press and release the power button.
[ Quiet Beep ]
How to reject a call
When the phone rings, press and
release the power button.
[ Ringtone Stops ]
How to clear misdialed numbers
Press and release the power button.
[ Quiet Beep ]
13) Keypad Lock Button
Press for 2 seconds and release keypad
lock and unlock button.
[ Audible Feedback ]
When keypad is locked, pressed buttons
will still beep, but will not dial out.
[ Alert Beep ]
14) Speaker
Loud speaker for hands free operation.
15) GPS
GPS antenna for location based
services. (optional)
GPS
16) Back Cover
RESPOND WITH
TEXT MESSAGE
1) “Call me back”
You can send a “call me back” text with
your SpareOne to numbers stored in
speed dial memories: Press * for 2
seconds [ Alert Beep ] then press
desired speed dial number on M1-M9.
[ Quiet Beep ]
[ Recieve second quiet beep if text
sent, error tone if no phone number
has been set up ]
SAFETY
1) Battery Information
SpareOne will work with the provided
battery. SpareOne accepts NiMH, Alkaline
or Lithium AA batteries. SpareOne will
not work with carbon zinc batteries.Ta lk
time and standby time will vary. We
recommend using Energizer Ultimate
Lithium L91 battery whenever possible
for better standby and talk time.
2) Warning
Risk of re. The battery can explode
or leak and cause injury if installed
backwards, disassembled, charged,
crushed, or exposed to re or high
temperature. Keep out of reach of
children & keep in original package
until ready to use. Dispose of used
batteries promptly.
SIM CARD
1) Insert SIM Card
Open the battery door and insert a
Micro SIM card. Make sure the metallic
contact is facing down.
2) Nano SIM card
You can also insert a Nano SIM card by
using a Nano SIM card adaptor.
SERVICE & SUPPORT
1) One-Year Warranty
Your SpareOne hardware (excluding the
AA Battery) is under a 1 year warranty
from original date of purchase.We do
not warrant against normal wear and tear,
nor damage caused by accident or abuse.
To obtain service, call SpareOne or visit
our website. Available service options
depend on the country in which service
is requested. SpareOne service may be
restricted to the original country of sale.
Charges may apply. Full terms and detailed
information about obtainingservice are
available at www.spareone.com/support
2) Visit our website and
follow us on social media
User manual, pictures, questions, how-to
videos, FAQ, contact information
www.spareone.com
All the latest events and news are
waiting for you!
Facebook: [ SpareOnePhone ]
Twitter: [ @SpareOnePhone ]
COMPLIANCE STATEMENT
SpareOne™ is a trademark of TennRich International Corp. ©
2014 TennRich International Corp. Energizer and other marks
are trademarks of Energizer.
FCC Warning
hen using any body worn accessory, please help to make sure
W
it as least 1cm clearance between phone and human body.
The body worn accessory should not contain any metal. This
device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may
not cause harmful interference. (2)This device must accept
any interference received, including interference that may
cause undesired operation.
Specic Absorption Rate (SAR):
SpareOne has also been tested against this SAR limit. The
highest SAR value reported under this standard during
product certication for use at the head is 0.067W/kg. The
highest SAR value reported under this standard during
oduct certication for use at the body is 0.087 W/kg.
pr
Changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Designed and manufactured not to exceed the emission limits
for exposure to radiofrequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These
limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The
guidelines are based on standards that were developed by
independent scientic organizations through periodic and
thorough evaluation of scientic studies. The standards
include a substantial safety margin designed to assure the
safety of all persons, regardless of age and health. The
exposure of measurement is known as the Specic
Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6W/kg. Transmitting at its highest certied power level in all
your mobile phone is a radio transmitter and receiver. It is at
the highest certied power level, the well below the
maximum value. This is power levels so as to use only the
power required to reach the network. In general, the closer
you are to a wireless base station antenna, the available for
sale to the public, it must be tested and certied to the FCC
that it does not exceed the limit established by the
government adopted requirement for safe exposure. The
tests are performed in positions and locations (e.g., at the ear
and worn on the body) as required by the FCC for each model.
The FCC has granted an Equipment Authorization for
evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model the Display Grant
section of http://www.fcc.gov/oet/fccid after searching on
FCC ID: 2ACDO-SO3GA.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
14
Scan to visit
www.spareone.com
for more information.
15
16
SOUM_2_EN_1.0