Xomax XM-VRSU720BT Installation Manual

7 Inch Million Multi-color Illumination

TFT Touch Screen

Detachable Control Panel
Remote Control
Control Panel USB Port and AUX Input

Memory Card Slot
AM/FM-RDS Digital PLL Tuning Radio

BT Compatible

INSTALLATION MANUAL

XM-VRSU720BT

CAR AUDIO/VIDEO SYSTEM

To ensure safety while driving

and to comply with laws,

drivers should not watch video or

operate the video device while driving.

Precaution

THANK YOU FOR PURCHASING PLAYER .

Before operating the unit, read this manual thoroughly and keep it handy
for future reference .
To avoid injury or accident , read the following precautions before
installing and operating the unit .

A SOUNDSTORM MULTIMEDIA

ABOUT THE LIQUID CRYSTAL DISPLAY (LCD) PANEL

Do not press on the LCD panel on the unit as doing so can distort the
picture or cause a malfunction . The picture may become unclear , or the
LCD panel may be damaged .

NOTES ON CLEANING

-Clean the LCD panel with a slightly damp soft cloth.

-Do not use solvents such as benzine, thinner, commercially available
cleaners or antistatic spray .

-Do not use alcohol to clean the screen .

If your car was parked in a cold or hot place, the picture may not be clear .
The monitor is not damaged . The picture will become clear the temper­ ature in your car becomes normal .

DO NOT install any receiver in locations where;

- it may obstruct the steering wheel and gearshift lever operations, as this
may result in a traffic accident.

- it may obstruct the operation of safety devices such as air bags, as this
may result in a fatal accident.

- it may obstruct visibility.
DO NOT operate any receiver while manipulating the steering wheel, as
this may result in a traffic accident.
The driver must not watch the monitor while driving.
IF THE DRIVER watches the monitor while driving, it may lead to
carelessness and cause an accident.
IF YOU NEED to operate the receive while driving, be sure to look ahead
carefully or you may be involved in a traffic accident.
IF THE PARKING BRAKE is not engaged.“ ParkingBrake” flashes on the
monitor, and no playback picture will be shown.

- This warning appears only when the parking brake wire is connected to
the parking brake system built in the car ( refer to the electric connection)

ON INSTALLATION

Safety Information

CAUTION:

THIS DIGITAL VIDEO PLAYER IS A CLASS I LASER PRODUCT. HOWEVER

THIS DIGITAL VIDEO PLAYER USES A VISIBLE/INVISIBLE LASER BEAM
WHICH COULD CAUSE .

HAZARDOUS RADIATION EXPOSURE IF DIRECTED. BE SURE TO OPERATE
THE DIGITAL VIDEO PLAYER CORRECTLY AS INSTRUCTED.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT
REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, AND ANNOYING
INTERFERENCE, USE ONLY THE RECOMMENDED ACCESSORIES.

THIS DEVICE IS INTENDED FOR CONTINUOUS OPERATION.

This product incorporates copyright protection technology that is protected
by method claims of certain U.S. Patents and other intellectual property rights
owned by Macrovision Corporation and other rights owners.Use of this
copyright protection technology must be authorized by Macro vision Corporation,
and is intended for home and other limited viewing uses only unless
otherwise authorized by Macrovision Corporation. Reverse engineering or
disassembly is prohibited.

REGION MANAGEMENT INFORMATION:

This Digital Video Player is designed and manufactured to respond to the Region
Management Information that is recorded on a Digital Video disc. If the Region

number described on the Digital Video disc does not correspond to the Region
number of this Digital Video Player, this Digital Video Player cannot play this disc.

Installation



NOTES:

Choose the mounting location where the unit will not interfere with the normal
driving function of the driver.

Before finally installing the unit, connect the wiring temporarily and make sure
it is all connected up properly and the unit and the system work properly.

Use only the parts included with the unit to ensure proper installation. The use
of unauthorized parts can cause malfunctions.

Consult with your nearest dealer if installation requires the drilling of holes or
other modifications of the vehicle.

Install the unit where it does not get in the driver s way and cannot injure the
passenger if there is a sudden stop, like an emergency stop.

If installation angle exceeds 30 from horizontal, the unit might not give its
optimum performance.

Avoid installing the unit where it would be subject to high temperature, such
as from direct sunlight, or from hot air, from the heater, or where it would be
subject to dust, dirt or excessive vibration.

DIN FRONT/REAR-MOUNT

This unit can be properly installed either from "Front"(conventional DIN
Front-mount) or "Rear"(DIN Rear-mount installation, utilizing threaded
screw holes at the sides of the unit chassis). For details, refer to the following
illustrated installation methods.

'

30

Installation



If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, first remove
the PLASTIC TRIM OUT of the both sides away, then insert the two KEY PLATE into
left and right side of chassis as above illustration.

Installating the unit

DASH B OA RD

METAL MOUNTING
STRA P

HEX NU T

SPRI NG WA SHER

PLAI N WAS HER

TAPPING SCR EW

CONS OL E

SLID E BR ACKET
HOUS IN G

HEX BO LT

SCRE WD RIVER

TABS

KEY PLATE

PLAS TI C TRIM OUT

KEY PLATE

Electric Connection



WIRING CONNECTION

LIGHT GREEN

(B+)12V
REAR CAMERA SW ITCH

(B-)PARKING BR AKE

GREY

GREY/BL AC K

FRONT
RCH SPK.

VIOLET

VIOLET/ BL AC K

WHITE

WHITE /B LACK

GREEN

GREEN /B LACK

REAR

LCH SPK.

AUTO ANTENNA

BLUE

GROUND (B -)

MEMORY BACK-UP(B+)

IGNITI ON S WI TCH(B+)

RED

YELLOW

BLACK

REAR
RCH SPK.

FRONT

LCH SPK.

PINK

KEY GROU ND(BL ACK)

KEY 1(BROWN)

KEY 2(WHITE25$1*()

SUBWOOFER G REY

RCH RED

LCH WHITE

REAR OUTPUT CAB LE

FRONT RC A WHITE L

FRONT RC A RED R

VIDEO OUT YELLO W

FRONT R CA OUTPU T
CABLE

REAR CAMERA IN PUT YEL LOW

RCH IN RED

LCH IN WHITE

VIDEO OUT(2 ) YE LLOW

VIDEO IN YELLOW

AV IN

FUSE

RADIO ANTENN A JACK

Note:

the earth connection cable (parking brake B-) must be connected in order for
pictures to be played back to the monitor. If the cable has not been correctly
connected, the message “PARKING BRAKE” appears on the monitor.

ISO C ONNEC TOR

Remote Control

/

6&17

5

Button

Ref #

Function

1

2

3&7

AS /

4

AS function see as page 22 Scan operation.
In BT mode, press to receive a call.

8

9

Press this button to Open/Close the operate monitor .Long press
it to adjust the angle of monitor Upward/Downward.

Press this butto n to turn the unit ON , press and hold to turn the unit OFF.
Press it brie fly to select a desired work source .

/MOD

/OPEN

/

In Disc Playback mode, press for fast forward or back forward playback.
In Radio mode, pr ess to scan step by step.

PLAY/
PAUSE

In Disc Playback mode, press to pause playback. Press again to
start where playback stopped.

Press these buttons to skip ahead or back one track.

Repeat function for media playing;
In radio mode, press to select the store station 2.

TITLE

RPT/2

When playing a Digital Video, pressing this button will open the TITLE
menu which i s recorded on the media. When playing a VCD disc,
press this button to create a PBC (Playback Control) menu for the
disc to assist in making playback selections.

10

DISP/2

In video playing mode, press to show OSD menu;
In radio mode, press to select the store station 1.

Remote Control

Button

Ref #

Function

19

20

11

12

RDM/3

SUB-T/6

AUDIO/5

MENU/4

13&21

VOL+/-

Use these controls to adjust the volume level.

Random function for media playing;
In radio mode, press to select the store station 3.

Same opera tion as audio in page 26.
In radio mode, press to select the store station 5.

In Digital Video Disc Playback mode, pressing this button will
allow you to change the subtitle language on discs which ha ve
this as an option.
In radio mode, press to select the store station 6.

Press this button briefly to display the root level directory of a di gital
video disc .
In radio mode, press to select the store station 4.

14

15

16

BAND/

In Radio mode, press this button repeatedly to switch between
the five radio bands: FM1 > FM2 > FM3 > AM1(MW1) > AM2 (MW2).
In BT mode, press to reject a call.

MUTE

EQ

Press this button to turn off the audio. Press again to r estore the
sound to its prior volume level.

18

SEL

Press the SEL(in radio mode,press and hold the SEL) to switch

between BASS,TRE BLE,BALANCE, SWF VOL, SWF FREQ.
After switchin g on the desired mode above, rotate VOL knob to set it.

Press repeatedly to cycle through the different equalizer curve
presets you may wish to use for enhanced listening.

Remote Control

Using the Remote Control

Face the remote control towards the player front face IR mark (remote control signal

receiver).

Operation angle: About 30 degree in each the direction of the front of the IR mark.

Preparing the Remote Control

1.First push to inside as the direction indicated by the arrow (See )And then

Remove the battery holder as the direction indicated by the arrow (See ).

2.Replace the battery Set a new battery property with (+)side up as illustrated

(See ).

3.Insert the battery holder. Push in the holder to the original position(See ).

1

2

3

4

Inserting the Battery

Note :

The lithium cell in the battery compartment of remote control has been secured for

transport with a . Before initial use please remove this plastic so that the

remote control is ready for operation .

plastic

Changing of the view angle on multi-angle Digital Video media.