take a minute to circle your model above
and record your serial number
here in case you need it later
5
your safety matters
Please read through completely before using your XO Unit
To prevent damage to the door gasket, the door must be opened all the way before pulling shelves out.
The appliance must be positioned so that the plug is accessible.
Empty your XO unit before attempting to move the appliance. Moving while loaded may damage or
distort the frame.
The compressor will get HOT during operation / touching it may cause injury.
During installation follow all safety tips provided in this manual / appropriate safety equipment such as
safety glasses and work gloves should be worn.
Two people should move or lift your XO unit to prevent injury or damage.
Remov
Never cover the bottle racks with foil or other material which will impede internal air circulation.
For maximum efficiency, keep the door tightly shut unless loading or unloading and never overload your
XO unit.
Before installing, allow your XO unit to sit upright for 2 hours at the install site. This will allow the cooling
system to stabilize after transportation. Failure to follow this step may cause problems.
Never store perishable food products such as meat or cheese in your wine cooler or beverage center.
e all interior and exterior packing materials prior to installation and dispose of properly.
Location
Your XO unit should be located away from direct sunlight and heat sources (stove, heaters, etc.) which may
increase electrical consumption. High or low ambient temperature may cause units to work improperly.
The floor must be strong enough to support your XO unit fully loaded.
Your XO unit must not be installed in areas of where water or e
Your XO unit must not be installed near
where flammable, corrosive or hazardous materials are present.
xcessive moisture are present.
Your XO unit’s final installation must observe the correct minimum air clearances around and behind the
unit to ensure adequate ventilation. In addition, all ventilation openings must be kept clear and free of
obstructions, failure to do so will result in damage to the unit.
WARNING
NEVER use external heat sources to accelerate defrosting
NEVER permit unauthorized service or modifications to your XO unit
NEVER tamper with the sealed refrigerant system - this unit uses R600A Refrigerant which is flammable.
It should never be used in the vicinity of any flammable or explosive ignition sources.
ALWAYS FOLLOW THE ELECTRICAL SAFETY INSTRUCTIONS OUTLINED IN THIS MANUAL.
6
electricity - this is serious
Failure To Follow All Electrical Safety Measures May Result in Serious Injury,
Fire Or Death
All electrical work should only be performed by an
experienced, licensed electrician.
All XO units MUST be grounded for safe operation and
come equipped with a
purpose.
NEVER remove or disable the 3rd prong with an adapter.
NEVER use an extension cord to operate your XO unit.
Your XO unit is built to operate on 115V 60Hz and
should be plugged directly into a dedicated 15 amp
3 prong outlet. If you are uncertain as to the
voltage, amperage capacity or if the 3rd prong is
properly grounded - consult a licensed electrician.
3 Prong molded cord/plug for that
INDOOR USE ONLY:
XO Refrigerators, wine cellars and beverage
centers described in this manual are rated for
indoor use only.
Your XO Unit was designed to operate in a
room temperature ambient condition between
oo
60 F and 90 F.
Use in any area which is not temperature controlled
within that range, such as a garage or porch may
cause your XO unit to fail to function properly.
Use in any uncontrolled area or otherwise exposed
to the elements is hazardous and voids the warranty.
For outdoor installations - consult XO or your local
XO dealer regarding an outdoor rated model.
In regions where high humidity exists condensation
may appear on the glass and/or gasket seals.
For best operation, keeping the unit fully stocked
with product will reduce this.
To maximize the depth of the installation recess your outlet should be mounted flush with the wall.
Your XO unit should not share the circuit with any other
electrical devices as this may cause overloading,
overheating, blown fuses or tripping circuit breakers.
In a worst case this can pose a fire hazard.
NEVER handle your XO unit in wet conditions as this
can pose a severe danger of electric shock.
Exercise care when moving your XO unit to avoid
damage to the electrical cord. If the electrical cord of
your XO unit becomes worn or damaged it must be
replaced immediately by a qualified technician.
NEVER unplug your unit by pulling on the cord.
Unplug by gripping the plug firmly and pull out
straight from the outlet.
7
SERVICE 115V - 60 Hz - 1 phase
AMPS 15 Amp Circuit Breaker
Requires a Dedicated Outlet
GFI required for Outdoor Installations
All electrical work must be performed by
a licensed electrician
Serious injury, fire or death...
Okay -
a perfect fit
90°
Door Swing
WALL
Clearance
Gap
140°
Door Swing
WALL
Clearance
Gap
use free standing - or - install under counter
MODEL DIMENSION “A”
35 1/4” MAX
34 1/8” MIN
XOU15
XOU24
XOU30
15” MIN
24” MIN
30” MIN
ALL XO UNDERCOUNTER
UNITS ARRIVE PRE-WIRED
7"
WITH LOW PROFILE PLUGS
FOR EASY INSTALLATION
4"
“A”
SEE CHART
SS DOOR MODELS
INSTALLING WITH
THE HINGE SIDE
NEXT TO A WALL LEAVE A 2 1/4” SPACE
DOOR MUST BE
ABLE TO OPEN 90 .
o
OVERLAY PANEL
MODELS INSTALLING
WITH THE HINGE SIDE
NEXT TO A WALL DOOR MUST BE
ABLE TO OPEN 140 .
IF THE DOOR CAN’T OPEN FULLY - YOU CAN’T PULL THE SHELVES OUT.
when installing an overlay door unit,
you might use a recessed outlet or
cut the adjoining cabinet wall to
reach an outlet there...
8
o
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.