xmartO WP1324 Quick User Manual

xmartO PT camera (WP1324) Quick User Guide

A. How to add a PT camera to your existing system

1. Plug the PT camera to power and hard wire it to your NVR with a network cable (Plug the network cable to the LAN port if your NVR

has 4 Ethernet ports; Plug the network cable to the WAN port if your NVR only has one Ethernet port.).

1. Go to your system, right click the NVR mouse, then click Device Manage. Click “Refresh” on upper right to search for this camera. After

a while, you’ll see the camera with IP address 192.168.1.168 show up in upper box. As shown in below picture:

2. Click to choose the camera in upper box, then click to choose an unoccupied channel (No video source) in bottom box and click “Match

Code”, you will see below interface. Wait for the system to search and add devices.