1 / 12
GPS Vehicle Tracker
（GPS+GSM+SMS/GPRS）
User Guide
( Version V1.0)
GT06
Tracking system: http://en.gpsxitong.com/index.aspx
Username: IMEN(ID)
Password:123456
2 / 12
Preface
This manual shows how to operate the device smoothly and correctly. Make sure to read this
manual carefully bef ore using this product. The introduction in this book is just for your reference, if
product appearance and colors different from the real products, please follow the products.
Contents
1．Accessories
2． Product Features
3. Installation Instructions
4. Usage
5. Troubleshooting
6. Warranty
.1.
Accessories
1.1 Power Cord
1.2 Installation Guide
1.3 Microphone ( optional )
1.4 SOS button ( optional )
1.5 Relay ( optional )
.2． Product features
2.1 GPS and Quad Band GSM 850/900/1800/1900Mhz
2.2 Input Voltage :8-50VDC or 8-100VDC (optional );
2.3 Tracking by SMS/GPRS
2.4 Tracking on Mobile Phone
2.5 ACC ignition signal be detected , ACC ignition signal is detected , the vehicle's state be prompted ;
2.6 Built-in vibration sensor , to achieve the vehicle intelligent anti-theft ;
2.7 specific number can be set up for SOS alarm and Security alarm ;
3 / 12
2.8 SOS switch button for emergency calls for help ;
2.9 Internal / external microphone and speakers , remote audio monitoring and voice intercom function (
optional ) ;
2.10 Built-in backup battery ,to achieve illegal cutting line alarm ( optional ) ;
.3 . Installation Instructions
3.1 Preparation before installation :
3.1.1 Open the box, check the device model is correct, the accessories are complete, otherwise please contact
your dealer ;
3.1.2 choose the SIM card , the terminal needs to insert a GSM SIM card , optional Unicom or mobile GSM
card (Universal GSM network )
3.1.3 the installation of SIM card , take apart a terminal device , open the SIM card metal cover, put the SIM
card chip into the slot, cover the metal cover.
Note : ⑴ before installing or removing the SIM card , turn off th power switch on the Terminal sid e ;
⑵ terminal SIM card need to open GPRS function ;
⑶ terminal SIM card needs to open the caller display function ( based on the needs of customers to choose ) ;
⑷ If your SIM card is turned to input SIM PIN, please refer to your phone user manual and turn off the SIM
PIN fuction
⑸ please make sure that the SIM card has charge. .
3.2Installation the way of terminal installation is the hidden installation , it recommend to be installed by the
technical personnel specified by the distributor . notesas following:
3.2.1 In order to avoid to be damaged by the thief , Equipment selection should be hidden
3.2.2 No together with emission sources , such as Parking sensors, anti-theft devices and other automotive
communications equipment ;
3.2.3 can be fixed by using cable ties , or using a strong double-sided adhesive stickers ;
3.2.4 Equipment’s built-in GSM antenna and GPS antenna should be ensured that a positive upward when
installing ( toward the sky ) , and non- metallic objects blocking shield abov e and recommend the installation
location :
3.2.4.1 the front windshield hiding place beneath the decorative plates ;
3.2.4.2 Car meter ( epidermis of non-metallic material ) surrounding the shelter ;
4 / 12
3.2.4.3 below under car windshield after decorative plates ;
3.2.4.4 car door or inside the column ;
3.2.4.5 inside the electric car / motorcycle shelter beneath the dashboard or rear seat.
NOTE : If the metal layer or heat insulating layeris attached below the windshield , it will lower the received
GPS signal , resulting in GPS work’s
Malfunction , please change equipment installation location.
3.3 terminal outlet defined
1 , The red line is connected to the positive pole ,
2 , The black line is connected with the cathode of the power
3 , the orange wire is connected to ACC,
4 , the yellow line access Oil cut-off electric / lock the car relay.
3.4 Terminal wiring diagram
Please use the original power cord , the red line is the positive power , black for negative power , negative
Loading...