XF-W13FD WIFI Integration Manual
This module is installed in the IP TV and makes the TV surf the
internet, the installation and location are as following: the module is
installed in the place which the TV had been reserved, then connect
module and TV by cable link, the TV motherboard had been
integrated with module’s driver and operation software, so the end
user can watch the IPTV directly. The Modue integration is only
conducted by authorised or dedicated installers. The module
implemented by the module grantee itself and the module will
be only implemented in TVs
FCC CAUTION:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of FCC Rules. Operation is
Subject to following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including
interference that cause undesired operation.
FCC STATEMENT:
This equipment has been tested and found to comply within the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a different circuit from
that to which the receiver is connected
• Consult the dealer or an experienced TV technician for help.
USERS MANUAL OF THE END PRODUCT-TVS:
The end user has to be informed that any changes or modifications
not expressly approved by the manufacturer could void the user's
authority to operate this equipment. additional FCC part 15.19
statement is required to be available in the user’s manual: This
device complies with Part 15 of FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT-TVS:
The final end product TVS must be labeled in a visible area with the
following “Contains FCC ID: 2AJSWXF-W13FD, the following
FCC part 15.19 statement has to also be available on the label: This
device complies with Part 15 of FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The OEM integrator or the host manufacturer is responsible for the
overall compliance of the host products
Loading...