Xineron XIN-MPC-050 Installation Manual

New H.264 Network Camera

Installation Guide

English Version 1.0

Copyright ⓒ 2007

2

1. Product Description

This manual applies to the Network Camera.

The Network Camera supports the network service for an existing analog camera. An
analog image entered can be monitored on a real-time screen regardless of distances and
locations. By using its dedicated program, many users are able to have an access to the
Network Camera at once or a single user can monitor various network cameras at the same
time. It also enables users to play, store and retrieve a monitoring image by using a PC. All
the settings and real-time monitoring screens are also provided through an access to the
web.

The Network Camera is a one-port video Camera including two-way audio, fully featured for
security surveillance and remote monitoring needs. It is based on the DSP compression chip,
and can digitize one analog video source and make it available on the network as real-time,
full frame rate Motion JPEG and H.264 (or MPEG-4) video streams.

The alarm input and alarm output can be used to connect various third party devices, such
as, door sensors and alarm bells.

Installation Steps

Follow these steps to install the Network Transmitter on your local network (LAN):

1. Check the package contents against the list below.

2. Connect the Network Camera. See page 4.

3. Set an IP address. See page 5.

4. Set the password. See page 6.

Package Components

The system comes with the following components:

Network Camera unit Installation CD Installation Guide

Contents in the installation CD

1. The Network Camera User’s Manual

2. The NautilusClient16 User’s Manual

3. The Nautilus Server User’s Manual

4. The NautilusClient16 Installation software

5. The Nautilus Server Installation software

3

• Front View

NO

Function

1

Focus adjusting fixing screw

2

Auto IRIS lens connector

3

Setup Buttons

• Rear View

NO

Function

Description

1

Power adaptor terminal

Connects the supplied power adapter or an external
power supply 12V DC or 24V AC, max. 6.5Watt.

RS485 terminal

Connects PTZ or PT device.

2

Power Indicator

Indicates power input.

3

Status Indicator

Indicates camera status.

4

Video Out

Connects the video output. This BNC connector
provides a 1.0Vp-p/75 ohms composite video signal.

5

6pin Terminal I/O

Connects alarm In/Out, audio In/Out.

6

Reset Button

Executes the factory default.

7

Network connector
(PoE)

RJ-45 port compatible with 10/100Mbps, which have a PoE
function.