Xiaomi Yeeligh, t YLDP01YL User Manual

User Guide for

Yeelight LED Bulb (White)

Basic Parameters

Installation Steps

Install the Light Bulb

Install the light bulb and switch on the power.

1. Make sure that the power is off when installing,
removing or examining the light bulb.

Model No.: YLDP01YL
Luminous flux: 580 lm
Lamp fitting: E26
Rated power: 8W
Rated power input: 120V ~ 60Hz 0.2A
Operating temperature: -10 to +40℃
Working humidity: 0% - 85%RH
Color temperature: 2,700K
Life expectancy: Approx. 25,000 hours
Wireless connection: Wi-Fi IEEE 802.11 b/g/n 2.4GHz
Size: 55 × 120 mm

Notes:

Download the Mobile Client

Search Yeelight in an app store or scan the QR
code below to download the Yeelight mobile client.

Run the mobile client

Open the app and operate it in accordance with
the instructions provided in the app.

*Make sure that your Wi-Fi connection is working.

How To Restore Factory Settings

Turn on and off the switch (not the mobile client app
on/off button) continuously for 5 times. The light will be in
breathing mode. After 5 seconds, it will automatically be
reset to its factory settings.

2. Do not use this product in a lamp with a light
modulator to avoid damage to the product. (such
as a table lamp with a light modulator)

3. Do not use the product in a wet environment.

4. Using the light bulb in a narrow ill-ventilated tube
lamp shade is not recommended because this may
cause weak signals or heat dissipation issues.

1. Before using this product, please make sure that your
voltage is appropriate for this product’s working voltage.
Using this product with a voltage other than the one
specified may damage the product and cause safety
hazards.

2. Do not disassemble this product, as the light diodes can
cause damage to the eyes.

3. The light bulb will heat up when working.
Do not use it in a confined holder for an extended period
of time. Ensure sufficient ventilation for the light bulb to
allow for heat dissipation.

4. The optical radiation of this LED light product complies
with the “Exemptions and Requirements” of IEC
62471-2006.

5. For indoor use only.

6. Risk of electronic shock. Disconnect power before
installation.

7. Do not use where directly exposed to water.

8. Do not use with dimmers.

9. The light source of this product is nonchangable light
diodes(LED).

FCC Compliance Statement

Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s

Warning

authority to operate the equipment.This device complies
with part 15 of the FCC Rules.Operation is subject to the
following two conditions:

(1) This device may not cause harmful interference.and

(2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:

(1) Reorient or relocate the receiving antenna.

(2) Increase the separation between the equipment and

receiver.

(3) Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

(4) Consult the dealer or an experienced radio/TV

technician for help.

1. Make sure that the power is off when installing,
removing or examining the light bulb.

Please read this guide carefully
before using the product

Manufacturer: Qingdao Yeelink Information Technology Co., Ltd.

Address: F10-B4, Bldg B, International Innovation Park,

#1 Keyuanwei Rd, Laoshan District, Qingdao City

Website: www.yeelight.com

Customer Service Email Address: [e-mail]