and simultaneously tighten two screws
using a hex key (5 mm).
Pedals х 2Power
adaptor х1
Quick start
Installation (assembly) of a steering tube
Wrench (15мм)
х1
Hex key (5мм) х1
Adjusting a saddle height
Maximum safe height
Loosen a saddle clamp, and then select an
appropriate position and height of a saddle.
Tighten a clamp of saddle pin. Note that it
should not exceed maximum safe height.
Recommended saddle height:
Install the steering tube in a vertical position. Make a tight conjunction between steering pipes and a lower part of the bike.
Lift the latch to secure a position of a steering tube.
stature
Page 3
Installing of pedals
To install pedals you must use a
wrench (15mm):
Pedal to the left leg tighten counterclockwise, pedal for the right foot - clockwise.
Wrench (15мм)Left foot
pedal
Switching on
1. Charging
Before rst use of bicycle you must charge the battery.
Right foot pedal
Top button
Bottom button
Note: after turning the bike on, you must
wait about 10 seconds to torque sensor
switched to a starting position.
Power button
Managing a display
Switching on/o the bicycle
Press and hold a power button for 3
seconds.
Note: If battery level is low, it goes into
sleep mode.
Please promptly charge the battery and
then use a vehicle.
Power button
Switching on/o lights
Hold a top button to simultaneously turn on
/ o front and rear lights.
2. Switching on
Press and hold for 3 seconds a button, located at the bottom of
display.
Press and hold a bottom button to turn on /
o a rear headlight.
Page 4
Installing an АРР
1. Scan the QR-code, to download an APP.
2. At rest, press the top/bottom display button to
switch a connecting interface of application.
3. Once registered, scan the QR-code, which is
shown on the main page. Connection succeeded.
Note: At the APPyou will nd more information
on management and use of the vehicle.
Battery and charging
Battery charging
Open a ip cover of port to charge
a battery, remove a protective cover
2. Press an engine control lever and
remove a battery.
Page 5
Gear shift
On the right side of handlebar is
built-in Shimano switch.Scroll down a handle to switch to a higher gear.Scroll handle up to switch to a lower gear.
The presence of toxic and hazardous substances
O: toxic and harmful substances in all components of the device are
contained in an amount below a limit value, according to standard GB / T
26572-2011.X: presence of toxic and hazardous substances at least one of components
of the device in an amount that exceeds a threshold, according to GB / T
26572-2011.
Folding pedals
1. Slightly press a pedal.
2. Then fold it without applying much eort.
Warranty
After-sales servicing is carried out according to law on «Consumer rights»
and «Law on product quality.»
Warranty service includes:
1. Within 7 days of purchase, in case of problems with «List of faults» service
center determines the cause of the problem, then you can choose a free
replacement product or a refund.
2. Within 15 days of purchase, in case of problems with «List of faults»
service center determines the problem, then you can choose a free
replacement product or repair.
3. Within 12 months after the purchase, in the event of a problem with «List
of faults» service center determines the problem and then you can choose a
free repair.
Page 6
Warranty
Conditions, are not included in warranty:
1. Awarranty period has expired;
2. Absence of sales receipt or it correction;
3. Damage, arising under force majeure circumstances;
4. Completion of maintenance, fall, neglect, abuse, water impact, accident, damaged label
and marking device;
5. Device model, specied in the warranty card, does not match real goods;
6. Performing maintenance device, that does not meet guidelines, specied in instructions;
7. Emergence of unusual sound and vibration of pedals, rear bushings, steering systems, shock absorber, ywheel and other parts;
8. Deformation of wheels as a result of a heavy blow; damage to parts, caused by external
factors or drop the bike; lowering the wheel as a result of a sharp object punctured;
damage to individual components due to delayed replacement parts; damage or scratches
on a saddle; frame damage as a result of installing a saddle above the specied limit
height;
9. An emergence of aking varnish, appearance of corrosion on a frame and other details of
the bike due to moisture, shock, friction or other external factors; natural shedding varnish or
fading of colors on metal and plastic parts after prolonged use of the vehicle;
10. Damage to the bicycle and its functions, as a result of its use to perform tricks, lowering
the stairs, jumps and other similar actions;
11. Fracture or deformation of a frame as a result of excessive and improper use of a
bicycle;
12. Built-in sensors are not subject to multiple charging. Awarranty terms not apply to a dry
battery, push-button type battery. When battery is spent, its replacement is performed by
user and one`s costs.
Page 7
Cautions
Battery and its charging
• Charge a battery at temperature of 0C - 45C. Keep a battery dry. At a temperature of 20S - 60C battery is low.
• Do not immerse a battery in acidic and alkaline liquids. Avoid exposure to rain, keep a battery away from heat sources and do not leave it in high
temperature and moisture.
• It is strictly forbidden to break, spoil, disassemble a battery and do actions,
that can cause a short circuit.
• To recharge a vehicle, use a power adapter, that comes as original
equipment. Do not leave a bike on a charger for more than 6 hours, a charging current does not exceed 2A.
• If over time a vehicle is not in use, please keep a battery in a dark, dry and cool place. Every two months, put a battery on a charger for two hours.
• Charge a battery in accordance with guidelines specied in instructions, or it may be an accident.
• Note the power adapter can be used to recharge a battery of only one type, at a certain voltage and current. It is strictly prohibited to use a power
adapter for charging other devices.
• When charging batteries need to install it in a well-ventilated place. It is
strictly prohibited to charge a battery in a closed room or in a room with a
high temperature.
• During charging, rst insert a battery and then connect an adapter to power supply. After a full charge, disconnect a power adapter from a power supply, and then disconnect it from a battery.
• If indicator light up green, you need time to disconnect a battery from a power supply. It is forbidden for a long time to leave a battery connected to a power supply after full recharging.
• During recharging, if indicators begin to light up in unusual way, an odor appears, or outer surface of an adapter become very hot, immediately turn o a battery from the power supply. You may need to repair or replace the
device.
• Do not let outer substances to penetrate to a power adapter, do not
immerse it in water or other liquids to prevent internal short circuit.
• Do not continuously transporting a power adapter in a vehicle. If you
need to transport a power adapter, don`t expose it to strong shock during
transportation.
• Do not disassemble or modify a power adapter.
Riding
• Carefully read instructions, nd information about the device and review
conditions, under which it is not recommended to use a vehicle. Do not pass
a vehicle for people who cannot manage it.
• When traveling by bicycle, please wear a helmet safety, follow trac rules.
• Before traveling, check an air pressure in tires of a bicycle, recommended
pressure is 35-45 PSI.
• Speed of a bike must not exceed 15 km / h, not recommended mode gain.
• When traveling, do not expose engine to excessive shaking and severe
shocks, periodically lubricate spindle.
Brakes
• Before a trip, carefully check a status of brakes.
• First recommended brake is rear brake.
• Watch closely for wear of brake pads. If brake pads worns on 1/3,
promptly replace them.
• In rainy and snowy weather we recommend to increase a braking
distance.
Maintenance and storage of a bike
• Keep your bike in a dry place, avoid direct sunlight.
• Timely lubricate a chain.
• Regularly check all bolts and fasteners of all places, in time to tighten
them if necessary.Recommended twisting force: (on unit: N*cm) screws with washer - 60-80,
screws stem 175-200, 175-250 saddle screws, bolts wheels 320-450.
• A degree of chain tension varies 2 cm. If this gure is less than 2 cm,
please adjust a chain tightness.
Page 8
The client company: Xiaomi Ecosystem company «Qiyi (Xiamen)
Technology»
Address: Xiamen, Huli District, Anling Street 97-99, 8 Floor, 01-07 Block
Main parameters
Model: EF1;Size: 1290 x 540 x 910mm;Weight: 14.5kh;Front fork: made from aluminum alloy;Saddle pin: 33.9 x 580mm (produced from aluminum alloy)Wheel size: 16 inches;Method of braking, front brakes, rear brakes Shimano IM31;Engine type: electric;Rated speed: about 260 r / min;Power input: 36V --- 6A;Protection of the voltage: 24.5V;Battery Type: 18650 mAh lithium-ion battery;The duration of continuous use: 45 km;
Display: 1.8 inch, 160 x 128 TFT;
Type of wireless connectivity: Bluetooth 4.0;
Standard: Q / XMQJ001 - 2016;
A distance between front and rear wheels: 870 mm;
Payload: 100 kgFrame: Aluminium crank 52Tx 170mm;Bushing: three-speed rear hub Shimano;Stopping distance: on dry road no more than 4 m, in a wet - no more than
15m (speed bike 20 km / h);Continuous output power: 180 W;Rated output torque: 7.3 Nm;Maximum speed: 20 km / h;Overcurrent protection: 10;Battery Capacity: 5.8 Ah / VTG 208.8;Maximum charging voltage: 42 V;Recharging time: 3 hours .;CMIITID: 2016DP2241.
XIAOMI-MI.COM
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.