Xiaomi Mijia User Manual

Overview

Lid

MIJia Electric Kettle

User`s Manual

Before using the product, carefully read the user’s manual and

keep it properly

Spout

Body

Base

Open lid button

Handle

Power button

Power plug

XIAOMI-MI.COM

Using

Care and cleaning

Опустіть

1. Click on button to open a lid of the
kettle, add water.
The water level must not exceed the
maximum mark, and should not be
below the minimum.

3. Press the power button, the button
will light, the water will begin to heat
up.

2. Close a lid, put the kettle on a
base.

4. After boiling water, the heating
will stop.

Precautions:

1. Make sure it is disconnected from a power supply and wait until it cools down before
cleaning the kettle.

2. To extend a service life of the kettle, it must be cleaned regularly from the sediment.

3. If water quality is poor, repeat an above procedure. In no case do not use an iron brush and
any abrasive chemicals to clean the kettle.

4. Do not immerse the kettle and its base in water. Keep the outside of the pot dry.

1. Add a vinegar.
Pour 0.5 l of vinegar into the
kettle and leave for 1 hour.

3. Boil water.
Boil water in a kettle and then

pour it o󰀨. Repeatedly wash the

kettle 4-5 times.

2. Pour o󰀨 a vinegar.

Pour the vinegar out of the kettle and remove
the sludge residues using a damp cloth.

4. Wipe dry the kettle.
Use a dry cloth to wipe the outside of the
kettle.
Keep the kettle in a dry, well-ventilated place,
protecting it from dust, moisture and insects.

Troubleshooting Precautions

• Children, elderly and people with disabilities can use the device only under the
supervision of others. Make sure that your children does not use this device as their
toys. Do not install the appliance in easily accessible places.

• Disconnect the device from a power supply in following cases: when there is no
water in the kettle, during addition of water in the kettle, unless you use the kettle,
while cleaning or rearrangement, if a problem occurs.

• Do not place the unit on an uneven or unstable surfaces. Install the unit away from
the heat source to avoid damage to the plastic components. The device can also be
placed close to other appliances or to them.

• Nominal device current is 10A, rated voltage - 220V with electrical zero. Do not use a
universal socket at the same time in combination with other appliances.

• If a power cable is damaged, contact the manufacturer, the maintenance department
or other similar departments for maintenance device, in order to avoid a dangerous
situation.

• This device is only intended for boiling water. Heat substances other, than water, are
prohibited. (Example: seaweed, eggs, soy milk, tea, milk, noodles, etc.). Otherwise,
problems may occur. Water level must not exceed a maximum mark, or it may cause
water leakage.

• Use the electric kettle with the base, which was originally bundled with it. Do not use
extraneous base for the kettle.

• Pour water into the kettle and before you put it on a base, wipe the device.

The presence of toxic and hazardous substances

0: toxic and harmful substances in all components of the device are contained in an amount below the
limit value according to SJ / T11363-2006 «Limit requirements for toxic and hazardous substances in
products.»
X: indicates the presence of toxic and harmful substances, at least one of the components of this product
in excess of the limit value, according to SJ / T11363-2006 «Limit requirements for toxic and hazardous
substances in products.»

XIAOMI-MI.COM