Xiaomi SWDK Electric Mop, D260 Instructions Manual

SWDK Electric Mop

Safety Information

Using

- Before use it is necessary to remove debris from the oor surface, this device does not

sweep and does not draw dust;

- This device is not water resistant, it is forbidden to wet it, use it for surfaces on which there
is a sticky liquid or a large amount of water;

- When cleaning a small room, various objects may interfere with the normal operation of

the device, possibly jamming. If this situation occurs, turn o󰀨 the device using the on/o󰀨
button on the handle, then move the device to a di󰀨erent location;

- It is strictly forbidden to increase the load on the main device;

- Children are not allowed to play and stand on this device;

- Clean the device with a clean towel, the device must be o󰀨;

- Do not put too much pressure on the device or carry it on your shoulder;

- Carefully polish the oorboard (made of wood), observe all safety rules;

- Please use this device in accordance with all the rules stated in the manual, otherwise
there may be various damages for which the user is responsible.

Instructions

Before use, read the instructions carefully

Using the device

Thank you for choosing SWDK Electric Mop!
Uniform wet cleaning of the entire apartment, fan-shaped spraying with water dust, the
mechanism of reciprocating movements of the mop, convenient and high-quality cleaning of
ceramic tiles, marble, parquet and other surfaces.

Use a special clean cloth or waxed head for polishing the oor surface. Easy and highly
e󰀨ective house cleaning.

SWDK Electric Mop is designed to facilitate your daily life. Pleasant use!

Battery and charging device

- Do not use foreign batteries or power supplies;

- Do not disassemble or repair the battery and power supply;

- Do not leave the power supply near a heat source (for example, near a heater);

- Do not carry out any action with the power supply unit with wet hands, do not wipe it with a
damp towel;

- Do not dispose of the battery with daily waste. Give it to the appropriate place of collection
of batteries, batteries, etc. for their further special disposal;

- If the power supply cord is broken or damaged, immediately stop using it, contact the
customer support department in a timely manner;

- For transportation of goods it is recommended to use the original packaging, make sure

that the device is o󰀨;

- If the device is not used for a long time, charge the battery, turn o󰀨 the mop, and place it in

a cool dry place. To avoid excessive discharge of the battery, it is recommended to charge it
every three months.

Overview

Assembling

Water Spray Button

On/O󰀨 button

Handle

Charge level indicator

Hole for lling with water

Additional accessories

Water spray hole

Textile Velcro

Click on the lock on the metal pipe,
successively connect all parts of the mop
together.

Attention: if the lock does not
open, please, by light rotating
movements connect both parts of
the metal pipe.

Place the main unit on the surface by
pressing on the lock of the metal pipe,
insert it into the mop connecting lever.

Lift the connecting lever to the upright
position.

To raise the connecting lever from the
folded horizontal to the vertical position, a
small force must be applied.

Put the fabric head on the oor, in

accordance with the position of the head, put
a mop on it. Then it will attach to the main
unit with velcro.

Water tank Durable fabric head x2 Disposable fabric head

Power adaptor Manual

Using

On/O󰀨

By pressing the power button on the squeegee handle, you will hear
a characteristic click, the charge level indicator will light up and the
device will switch to the standby mode.

If the mop handle is in vertical position, the unit is turned o󰀨.

Caution: in the absence of any action for two minutes, the device
goes into standby mode. In this case, 100% of the charge level

ashes on the display. Move the handle to the upright position and

pull back towards you to return to normal use.

Using

Using

Filling the tank with water

Open the lid of the water tank, holding it by hand,
pour distilled water using a measuring glass.
Pour water in the mop to the mark «MAX», close
the water tank with a special lid.

Caution: The capacity of the water tank is 230
ml.

Make sure that the water, you want to ll the

tank, is clear and free of impurities, otherwise the
device may break down.

Switching on/spraying

Remote control of mop operation and water
spraying.
In standby mode, press the power button, after
which the mop will turn on and begin to perform
reciprocating movements. Press the button again

to turn o󰀨 the device. Periodically press and hold

the spray button to spray water.

Spray button

On/O󰀨 button

Charge levels of the device

3 indicators - 100%;
2 indicators - 65%;
1 indicator - 30%;

3 ashing lights - low charge.

First charging

Remove the rubber plug from the port to recharge the
device, plug the power adapter into the appropriate
connector.
Attention: use the original power adapter.

Changing a head

Step by foot on a special mark on the fabric head, lift the
device to separate it from the mop.

Precautionary measures

Release the spray button to stop spraying the water.
Caution: when the battery level is low, the remote control function does not work
The maximum possible holding time of the injection button is 5 seconds
For normal response with remote control, the intervals between each push of a button
should be longer than 1 s.

Charge level indicator

Each of the three indicators of the charge level
corresponds to a certain percentage of the
charge level - 100%, 65% and 30%. When all
three indicators blink, the charge level is low.

Charge level

indicators

Handle

The mop can be automatically locked if the device is turned o󰀨 and the handle is in a level

vertical position.

Textile velcro

After repeated use on textile velcro, there may be a lot of di󰀨erent foreign objects, dust,
which reduces the e󰀨ectiveness of its stickiness. Please use a soft brush to periodically

clean a velcro from foreign objects.

Fabric head

After each use, remove, wash and dry the fabric head or use disposable fabric head.
Disposable fabric heads are made of environmentally friendly material, with repeated use

their e󰀨ectiveness is reduced.

Water Tank

In the water tank it is necessary to add distilled water without impurities. After using the
mop, you need to drain the rest of the water. If special essential oils are added, rinse the
water tank several times after use.

Main parameters

The presence of harmful and poisonous substances

The presence of harmful and poisonous substances

Circuit board

Components

Troubleshooting

In the event of a malfunction, try to restore the normal operation of the
device using this table.

Body

Dry Battery

Battery

These tables are provided in accordance with SJ / T 11364.

O: Toxic and harmful substances in all components of this device are contained in an

amount below the limit value in accordance with standard GB / T 26572-2011.

X: the presence of toxic and noxious substances in at least one of the components of this

device in an amount exceeding the limit value, according to GB / T 26572-2011.
(All components marked «X» comply with the EU RoHS standard, or world technology

developers have not yet found a way to notice the harmful substance that is contained in

the details).
(This table contains our company’s data on the presence of harmful substances in our
products, but not all devices have all of the above components).

It is environmentally safe to use the device with a dry battery for 3 years.
It is environmentally safe to use the device with a battery for 5 years.

SWDK Electric Mop

SWDK Electric Mop List of Faults

Some of the functions, described in the instruction, do not work;

•

• The device does not turn on;

• Problems with the normal movement of the device, problems with water

spraying;

• Problems with normal power supply.

Manufacturer: Ningbo Sawadeka Electric Appliance Co., Ltd;

Model: D260 (* There are no notications for updated models);
Standard: DB4706.1-2015 GB4706.57-2008 Q / SWDK 01-2017;

Address: Yuyao City, Zhejiang Province, Yangming Street, Fangqiao Industrial Park, 129
Yucai East Road;
Website: www.swdk.com.cn;

Telephone technical support: 0571-879652 10;

e-mail: [e-mail];

Fax: [phone]; 0;

Sales center: Zhejiang Province, Hangzhou City, Xihu District, Sandun Sujia Road, Huacai

International Building 2, 8th Floor;
National free phone service: 400-665-0037.

Warranty

Conditions, that are not subject to warranty

Warranty service is carried out in accordance with the law on «Consumer Rights of the

People’s Republic of China» and «Law on the quality of China’s products.»

Warranty service includes:

1. Within 7 days from the date of purchase, in case of a problem from the «Fault List», the

service center determines the cause of the problem, after which you can choose a free
replacement of the goods, return or repair.

2. Within 8-15 days from the date of purchase, in the event of a problem from the

«Fault List», the service center determines the problem, after which you choose a free
replacement or repair.

3. Within 12 months from the date of purchase, in the event of a problem from the «Fault
List», the service center determines the problem, after which you are provided with free
repair.

4. In case of using the device in public places (shops, schools, etc.), the warranty for the

main device is provided for 3 months, and for basic components - for six months.
Recommendation: for the safe transport of the device, special packaging must be used. It
is recommended to keep the packaging of the goods within 30 days.

1. Maintenance of the device in unauthorized service centers, improper use, fall,
negligence, abuse, liquid ingress, accident, damage to the label and labeling of the device;

2. The warranty has expired;

3. Damage caused by force majeure;

4. Breakdowns that do not correspond to the «List of faults» of the service center;

5. Breakdown of the device from the «List of malfunctions», which have arisen in
connection with the human factor and which prevent its normal operation;

6. The time of the purchase is not specied.

Required documents, identifying the time of the purchase (including a sales receipt,
invoice, purchase order screenshot, etc.). If the time of purchase can not be determined,
the date is 60 days after the release of the product (according to the quality certicate) is

considered to be the beginning of the warranty.

Note: no warranty is provided for consumables.

XIAOMI-MI.COM