User Manual
product introduction
Products for the electronic table form, can not removable after wearing, with waterproof and
tamper function
Products built-in RFID module and the vibration motor, connected via RFID module and
Community Corrections supervision terminal. When the watch battery is too low or the separation
of the two exceeds 15m, the watch will vibrate to indicating the wearer
product appearance
Use schematic
1、 nsert the strap buckle clasp from the insertion position
watch button
watchband
2、 according to personal wrist size, adjust the strap length, the user can wear comfortably
watch button
loop
3、 the four pillars shell table wear on the alignment hole strap and buckle in the clasp
product specs
waterproof
use methord Wristband style
display screen
material Silica gel
standby time month
RFID
color black
R433，effective distance
IP67
PMMA
FCC
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Loading...