base station instruction
product model
name
HX-5208
external adapter
specs
input)AC 100-240V~50/60Hz 0.3A output DC5V 2A
base station
power
=0.5W
built-in battery
lithium battery 2300mAh
work temperature
-20℃～+60℃
storage condition
temperature-20~+35℃，relative humidity 45~75%
weight
209g±10g
size
159.6mmX99.5mmX30.6mm
一、base station configuration table
二、base station operate instruction
1. the base station interactive features description
external power indicator (red)
function indicator (yellow): If the base of the code is successful, the function
indicator flashes to 1HZ five consecutive times. The base station normal
operation, the function indicator flashes in 1-minute period
If the device is an illegal move, there will be a buzzer to 1HZ frequency drops
continuous alarm rang five times
2. automatic code function
after the success of the code, the equipment that is the correct mobile positioning
terminal complete the binding work, this time, if the correct person within the
portable mobile positioning terminal into the indoor wireless coverage RFID base
station, the mobile positioning terminal will automatically recognize the base
station, and base station location information reported to the management
platform
3. base station alarm function
RFID indoor positioning station into operation once, the device can not arbitrarily
move, if they are illegal move, the device will save dismantle alarm status until
after the mobile positioning terminal to report alarm information
4. base station down operation function
RFID indoor positioning base built-in rechargeable lithium battery, external
power supply is unplugged or if the indoor power outage, the device can work at
least 48 hours
对码开关
三、base station installation instructions
Installation environment
Place the router horizontally or vertically hung on the wall
Try to place the router away from heating devices
Do not place the router in dirty or damp places
base station installation steps
1. external connect with power adapterand power
2. If the device is installed on first use, need for the operation of the code
(non-first-time installation, skip this step
code steps
1.Code will switch to ON
2.the power switch to the ON
3.Set your phone base station ID, channel and serial number
code switch
Phone settings ID, channel and serial number
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
*RF warning:
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
Loading...