Instruction of X11 True Wireless earbuds
Thanks for purchasing Padmate X11 True Wireless earbuds. You will need to pair the
device with your mobile phone or other Bluetooth enabled devices in order to experience
its great performance. Please read through the instruction m anual below before using.
I. IMPORTANCE BEFORE USING:
The unit was designed and produced according to the related quality requests and safety
standards. Please read through the following operation instructions before using it:
1. Read and keep well these instructions;
2. Do not use or operate the it where it is forbidden of using, for example, airplanes and
hospitals;
3. Do not use or operate the it according to the local laws and rules, for example, do not
use it when drivi ng;
4. Do not use or operate it when you are close to explosive or flammable sources, eg,
gas station etc;
5. Do not hit or throw or open the unit by force as it may cause damage to the device;
6. Do not put the unit near heat sources, eg, stoves, heat registers and radiators etc;
7. Keep the unit away from wet, water or other liquids that might cause short circuit or
malfunctions;
8. Keep the unit and its accessories away from children to prevent being swallowed
9. For special users, such as patients who use heart pacemakers, audiphones and
built-in cochlea devices etc, please follow the advice of doctors.
10. Using it below minus 15 ℃ or above 55 ℃ could shorten the life span of battery.
II. About The Device
2.1 Device controls and locations
1、Multi Function button 2、LED indicator 3、Silicon earbuds 4、Power ON/OFF button
5、Charging contact
2.2 Packing list
Bluetooth headset (left & right) *1 pair
Charging cradle with built power bank *1pcs
Instruction manual *1pcs
Quick start manual *1pcs
Micro-USB cable *1pcs
Silicon caps (L,M,S): 3 pairs
2.3 LED indications and modes
Earbuds LED indications (Blue & Red)
Pairing Blue and red glitter alternatively
Paired successfully
Blue glitters 3 times and goes off. (Voice prompt
“connected” can be heard)
Playing music Blue LED color glitters slowly
Low battery Red LED glitters slowly. ( Beep indication can be heard)
Charging Red LED on .
Fully charged
Red LED turns off and Blue LED turns on and will turn off
within 5 seconds.
Charging Cradle LED indications (Blue & Red)
Low battery in cradle Red LED glitter slowly
Charged by USB Red LED on
Fully charged by USB Blue LED on
Charging earbuds Red LED on
Earbuds fully charged Blue LED on
2.4 charging and battery
Please use the original USB cabl e provided for charging.
Warning: Using unmatched USB cable for charging might damage the device. Also, you
are not permitted to take the battery out of the device in case of damage and
danger. Suggested input power is DC 5V, 100mA-2A max.
III. Operations
3.1 How to pair
NOTE: The left and right headsets are paired already in factory. Users only need to pair
either of the headset to mobile phone device and power on the other headset. Then the
two headsets will both connect the mobile automatically. The selected headset for pairing
will be the master headset while slave-headset for the other one.
1. Please take your mobile phone close to the device. Suggested distance is less than 1
meter.
2. Push On/Off button of either headset for 3 seconds, then you will see blue and red LED
glitter alternatively. Now it is ready for pairing.