1. Door sta ti on s
L8 User’s manual
(Door station Model No.8)
Bas e + card re ader
2. Technical s pecific ation
Camera:
Viewing angle:
Lens:
Resolution:
Min. Illumination:
Video Output:
Audio SNR:
Audio Distortion：
Assistant door panel:
System Capacity:
Card and capacity:
Standby Current:
Work in g Cu rr en t:
Power supply:
Environment Temperature:
3. Structure
1
2
Pane l
4
5
11
7
10
10
Ass istan t panel 1 x8
Seal
③
①
3
6
9
Doo r stati on
4. Installation
Scre ws
②
Fram e
Ass istan t door pa nel 1x8
1/3" CCD
92°
F=3.6
420TV Lin es
0.01 Lux
1V /75Ω
P- P
≥25 d B
≤7%
Max.16pcs
Max. 132 apartments/building
≤50,000pcs; ID card(Format:EM, 125Kh); IC card (Format:
mifare 1 S50/S70, mifare Ultra Light, mifare Light, 13.56MHz)
≤116mA(direct-call)
≤450mA(direct-call)
DC12V(
for audio); DC32V(for video)
-40℃~+ 45℃
Scr ew
1
Mic ropho ne
2
Cam era
3
LED
4
Lig ht sens or
5
8
Spe aker
6
Nam e tag
7
Cal l butto n
8
Car d reade r
9
Pan el
10
Gua rd butt on
11
a. Produce a recangle groove as the installation size
(104x214x50mm) on a suitable position and then
fix the box in it with cements or screws(①).
b. Take off the screws and then the frame(②).
Box
c. Put the rubber seal on the back of door panel(③).
d. Put the door panel into the box and fix it with the
screws(③) after connection.
e. Put the frame on the door panel and fix it with the
screws(②).
1
5. Operation
5.1 Call indoor pho ne s
Push a call button on the door station.
5.2 Call the guard unit (if there is)
Push the guard button as the following figure.
5.3 Release door wi th r eg is tered card
Move the registered card over the card reader as the following figure.
6. Door sta ti on l is t
Pro duct p ode l numbe rs Size s: L x W x D (mm ) Exclu sive fe ature shot os Mode l names S eries m
JB- 5000 L8 -5002 MGC(8 )-8
Mod el No.8
XIMAN LEELEN TE CH NO LO GY CO.,LTD.
65, S UNBAN S OUTH RO AD, JIM EI, XIA MEN, 36 1021 CH INA
Thi s appli ance sh all not b e dispo sed tog ether
wit h the nor mal was te. It mu st be rec ycled .
Ati tude du ring op erati on belo w 2km.
JB-5 000 L8 -5002 MGLC-I P(8)- 8
JB-5000 L8-5002 MLC -IP(8)-8
2
24 0 X1 20X 58
With c ard rea der or wi thout .
With c ard rea der and 4 c all but tons
With 2 ~4 call b utton s
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Loading...