Xhorse Electronics S01 User Manual

Item

Description

1

switch button for mechanical key

2

lock button of vehicle or garage door

3

unlock button of vehicle boot

4

unlock botton of vehicle or garage door

1, pull the cover as the picture remarked

direction

2, remove the plastic as the picture remarked

direction

Universal Remote Key User Manual

Overview：

Xhorse universal remote key is suitable for vehicle and garage door which contains the Xhorse receiver.

Button Description:

Change battery：

First use or when the battery runs out need to change new battery, following steps:

3, take the battery out and replace new one

（Notes:the battery type is 2032 with 3

voltage,ensure the positive and negative of

battery is correct）

4, install the key same as before

While holding the lock and unlock key, the radio frequency of the remote control can be switched between

433.92MHz and 315MHz so to change to control the vehicle and garage door, as shown in the figure below;

Pairing method：

1)Pairing with vehicle: Referring to the corresponding vehicle models to match.

2) Pairing with garage door: Press the “learn” button of receiver for 2-3 seconds, then you can see the receiver led

light on, press your remote 4-5 time, after that, the receiver led light will continuous flashing, when it off, pairing

successes. If failed to match the receiver, please repeat the above method.

If you want to control both vehicle and garage, please separate the frequency.