XENO XPSU1208e, XPSU1216e User Manual

1

Ref: XPSU1208e / XPSU1216e

12V dc 4A/8A Low
Profile CCTV SMPSU

XPSU1208e XPSU1216e

4A: 8 x 0.5A Fused Outputs 8A: 16 x 0.5A Fused Outputs

Thank you for choosing this high quality 12V dc power supply. Before attempting to
connect or operate this product please make sure you carefully read these
instructions for your safety.

General:

A range of 12V dc power supplies capable of delivering fully rated current to load, housed within
a low profile metal enclosure, suitable for internal use only. Provided with 8 or 16 individually
PTC fused outputs ideal for low powered CCTV installations.

INSTALLATION AND SET-UP

This unit is only suitable for installation as permanently connected equipment and MUST be fed from a
mains power source having a separate (approved) disconnect device - fitted with a fuse or other over­current protection device rated at 3A maximum. Ensure that the disconnect device used has appropriate
earth fault protection to the applicable standard.

The enclosure is NOT SUITABLE for external use; bushings should meet a minimum flammability specification
of UL94 HB.

The PSU should be installed according to all relevant safety regulations.

1) Fix to wall or other support structure using the screws/fixings supplied or use appropriate types for the

surface it is being mounted to.

2) Mains input cable must be to the applicable standard with a 3A or greater current capacity, having a

minimum operating voltage of 300/500V ac.

3) The low voltage output cable must be correctly sized to carry the rated load current to the devices

connected to the PSU.

4) Mains input and low voltage output cables should be routed to use different entry/exit holes in the

enclosure.

5) To comply with current BS EN60950 safety legislation the supplied cable ties must be used to secure

mains input and low voltage output wiring.

Norbain SD Tel: [phone]

210 Wharfdale Rd, Fax: [phone]
Winnersh Triangle, Web: www.vista-cctv.com

Wokingham, Berkshire,

2

Ref: XPSU1208e / XPSU1216e

OPERATION

This unit is intended for use by Service Personnel only - There are NO USER SERVICEABLE parts inside.

The green Mains LED will be illuminated whilst the mains supply is present. In the event of a fault
condition, the red Fault LED will also be illuminated on the module.

MAINTENANCE

There is no regular maintenance required of this PSU.

If the output of the PSU fails the cause of the failure should be investigated e.g. short circuit load. The
fault should be rectified before restoring power to the PSU. The fuse(s) may need to be replaced.
Ensure the correct fuse rating and type is used.

DISPOSAL OF PRODUCT AT END OF LIFE

This product falls within the scope of EU Directives 2012/19/EU Waste Electrical and Electronic
Equipment (WEEE). At the end of life, the product must be separated from the domestic waste stream
and disposed via an appropriate approved WEEE disposal route in accordance with all national and local
regulations.

For more information see: www.recyclethis.info