Xenith SHOULDER PADS Assembly Instructions

HARDWARE CONTENTS

STEP 2

STEP 4

STEP 1

STEP 3

STEP 5

Feed lower end of attachment strap with
two grommets through slot in back plate
from outside to inside. Select inner or outer
slot to best match up with slots in
shoulder pad.

2 Attachment Straps
2 Elastic Hardware Covers
4 T-Nuts
4 Screws

Place elastic hardware cover onto attach­ment strap.

Feed upper end of attachment strap
through slot in shoulder pad from outside
to inside.

Feed upper end of attachment strap back
through elastic hardware cover

Align the two grommet holes on the lower
end of the attachment strap with one of
the grommet holes from the upper end, and
place a t-nut through the three grommet
holes from back to front. The vertical
position of the pad can be adjusted using
the dierent grommet holes.

STEP 6 STEP 7

Install screw through front of grommet holes
into t-nut and tighten.

Slide elastic hardware cover over t-nut and
screw. Repeat process from step 1 for
other attachment strap location.

ASSEMBLY INSTRUCTIONS: XENITH SHOULDER PADS

BACK PLATE

BACK PLATE
FRONT

HARDWARE CONTENTS:

STEP 4

STEP 1

STEP 5

Feed lower end of attachment strap with
two grommets through slot in back plate
from outside to inside. Select inner or outer
slot to best match up with holes in
shoulder pad.

2 Attachment Straps
2 Elastic Hardware Covers
4 T-Nuts
4 Screws

Install screw through front of grommet holes
into t-nut and tighten.

Depending on the shoulder pad model used,
select an existing hole, or a hole may need
to be drilled. NOTE: Drilling your shoulder
pad may void the warranty or cause
damage; do so only at your own risk. Feed a
t-nut through the hole in the shoulder pad
from the back, and through a chosen
grommet hole in the attachment strap. Pad
position can be adjusted by choosing
dierent holes. Install a screw through the
grommet hole and into the t-nut to secure
the back plate.

STEP 2

Place elastic hardware cover onto attach­ment strap.

STEP 6

Slide elastic hardware cover over t-nut and
screw. Repeat process from step 1 for other
attachment strap location.

STEP 3

Place a t-nut through the two lower
grommet holes in the strap from back
to front.

ASSEMBLY INSTRUCTIONS: NON-XENITH SHOULDER PADS

BACK PLATE

BACK PLATE
BACK