Xenarc Technologies 700IDT User Manual

700IDT In-dash Touchscreen VGA LCD Monitor

Owner’s Records

The model and serial numbers are located on the rear of the unit. Please record these
numbers in the spaces provided below, as well as the dealer name, address, and
telephone number. Please refer to these records whenever speaking to your dealer
regarding this product.

Model # _______________________ Serial # ______________________
Dealer Name _________________________________________________
Street Address ________________________________________________
City ___________________ State _______________ Zip ____________
Phone # ( ) _________________Purchase Date ____/____/____

www.xenarc.com

NOTE

NOTE 1: If you are trying to connect the monitor to a laptop computer, please make

sure to enable the 15-Pin D-SUB external monitor output located at the back of your
laptop computer. Some laptop computers have three modes: Laptop Display Only,
Laptop Display plus External Monitor, and External Monitor Only. If this is the case,
please switch to the External Monitor Only mode.

NOTE 2: Touch Screen device driver must be installed onto your computer in order for
the Touch Screen to become functional. Xenarc Technologies uses 4-Wire Resistive
Touch Screen panels in the 700IDT monitor. Touch Screen drivers and software for
different operating systems can be found in the included CD-ROM disc. You can refer
to this manual for a walkthrough of Touch Screen Driver installation under Microsoft
Windows XP. You can find other instruction manuals inside the folder named “Doc”
on the CD.

NOTE 3: The maximum voltage supported by the monitor is 24V DC. Feeding the
monitor with higher voltage will damage the monitor and void the warranty. Please use
a fused power source if you decide to wire the monitor directly to your car’s electrical
system. It is also crucial that you check the polarity of the connection.

NOTE 4: If the monitor is not displaying the VGA signal properly, the VGA signal
might be out of range. Try changing your display refresh rate to 60, 70, 72, or 75Hz.

NOTE 5: Please note that the LCD screen is made with high-precision technology.
However, black points or bright points of light (red, blue, or green) may appear
constantly on the LCD screen, and irregular colored stripes or brightness may appear on
the LCD screen. This is not malfunction. (Effective dots: more than 99.999%)

NOTE 6: Make sure your monitor has a Xenarc Laser Hologram sticker to validate the
authenticity of your monitor.

For Technical Support, please contact us at:

Xenarc Technologies Corp.
2770 S. Harbor Blvd., Unit A
Santa Ana, CA 92704
TEL: [phone]
Toll Free: 888-656-6536
E-mail: [e-mail]
URL: www.xenarc.com

2

8. Click Finish to finish the installation. You will be asked to restart your

computer.

Package contents

9. Remove the CD and Restart your computer. After Windows XP is finished

loading, connect the 700TS or 700TSV USB cable to one of your computer’ s
USB Ports.

10. Windows XP will start “Found New Hardware Wizard” automatically upon

detection of the USB Touch Controller. Click on Next to continue.

11. Click on Next to continue.

12. Click Finish to finish Setup. Your Touchscreen is ready to use now. You can

click on the icon Touchkit located on your desktop to launch the Touchscreen
program for various settings and adjustments.

1. 7” In-Dash Touch Screen monitor

2. Monitor cable - monitor to VGA (15 pin) and 2 x Composite

Video

3. Power cable

4. Cigarette lighter car adaptor

5. Remote control
* User Manual and Touch Screen Driver CD are included

14

3