Xenarc Technologies 1020TSV, 1020YV User Manual

8. Click Next to accept the Program Folder default, shown below. Files will
then start to be copied to your computer.
9. Setup will finish installing and tell you that The Touchkit driver has been
installed. Now plug the USB connector from your monitor into your computer. Click YES to perform 4-points calibration when asked to. Follow the instruction to touch, hold, and then release each of the four blinking X to complete 4-points calibration.
1020YV VGA LCD Monitor
1020TSV VGA LCD Monitor w/ Touch Screen
10. Your Touchscreen is now ready to use. You can click on the icon Touchkit
located on your desktop to launch the Touchscreen program for various settings and adjustments.
Owner’s Records
The model and serial numbers are located on the rear of the unit. Please record these numbers in the spaces provided below, as well as the dealer name, address, and telephone number. Please refer to these records whenever speaking to your dealer regarding this product.
Model # _______________________ Serial # ______________________ Dealer Name _________________________________________________ Street Address ________________________________________________ City ___________________ State _______________ Zip ____________ Phone # ( ) _________________Purchase Date ____/____/____
www.xenarc.com
NOTE
NOTE 1: If you are trying to connect the monitor to a laptop computer, please make
sure to enable the 15-Pin D-SUB external monitor output located at the back of your laptop computer. Some laptop computers have three modes: Laptop Display Only, Laptop Display plus External Monitor, and External Monitor Only. If this is the case, please switch to the External Monitor Only mode.
NOTE 2: If you have the 1020TSV, the Touch Screen device driver must be installed onto your computer in order for the Touch Screen to become functional. Touch Screen drivers and software for different operating systems can be found in the included CD-ROM disc. You can refer to this manual for a walkthrough of Touch Screen Driver installation under Microsoft Windows XP.
NOTE 3: The maximum voltage supported by the monitor is 24V DC. Feeding the monitor with higher voltage will damage the monitor and void the warranty. Please use a fused power source if you decide to wire the monitor directly to your car’s electrical system. It is also crucial that you check the polarity of the connection.
NOTE 4: If the monitor is not displaying the VGA signal properly, the VGA signal might be out of range. Please try changing your displa y ref resh rate t o 60 , 70, 7 2, or 75Hertz.
NOTE 5: Please note that the LCD screen is made with high-precision technology. However, black points or bright points of light (red, blue, or green) may appear constantly on the LCD screen, and irregular colored stripes or brightness may appear on the LCD screen. This is not malfunction. (Effective dots: more than 99.999%)
NOTE 6: Make sure your monitor has a Xenarc Laser Hologram sticker to validate the authenticity of your monitor.
5. DO NOT Plug in the USB connector from the monitor into your computer
when it asks you to. Simply Click OK to continue.
6. The setup program will ask you if you want to enable Multi-Monitor
Support. Click Next again to enable Multi-Monitor Support.
7. Click Next to accept the Destination Directory default, shown below. Click
on Browse to change Destination Directory.
For Technical Support, please contact us at:
Xenarc Technologies Corp. 2770 S. Harbor Blvd., Unit A. Santa Ana, CA 92704 TEL: 714-546-1018 Toll Free: 888-656-6536 E-mail: service@xenarc.com URL: www.xenarc.com
Loading...
+ 2 hidden pages