Xbrand HT9737SM User Manual

ELECTRIC FIRE DISPLAY

Item # HT9737SM

OWNER’S MANUAL

WARNING

CAUTION

Read and understand this entire owner’s manual, including all safety
information, before plugging in or using this product. Failure to do so could
result in fire, electric shock, or serious personal injury.

Keep this owner’s manual for future reference. If you sell or give this product
away, make sure this manual accompanies this product.

NO VENTING REQUIRED

120V AC; 60 Hz; Adjustable 600 Watts or 1500 Watts

2

IMPORTANT SAFETY INSTRUCTIONS!

WARNING

 Read all instructions before using this heater!

use it in areas where

ALWAYS plug heaters directly into a wall outlet/receptacle. NEVER use with an

 This heater is hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. If

provided, use handles when moving this heater. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of
the heater, and keep them away from the sides and rear.

 Extreme caution is necessary when any heater is used by or near children or invalids and

whenever the heater is left operating and unattended.

 DO NOT operate any heater with a damaged cord or plug or after the heater malfunctions,

has been dropped or damaged in any manner. Discard heater, or return to authorized service
facility for examination and/or repair.

 DO NOT run power cord under carpeting. DO NOT cover power cord with throw rugs, runners,

or similar coverings. DO NOT route power cord under furniture or appliances. Arrange power
cord away from traffic area, and where it will not be tripped over.

 Connect to properly grounded outlets ONLY.

 DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening, as

this may cause electric shock or fire, or damage the heater.

 To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. Doing so could

cause a fire. DO NOT use on soft surfaces, like a bed, where openings may become blocked.

 A heater has hot and arcing or sparking parts inside. DO NOT

gasoline, paint, or flammable liquids are used or stored.

 Use this heater only as described in this manual. Any other use not recommended by

the manufacturer may cause fire, electric shock, or injury to persons.



extension cord or relocatable power tap (outlet/power strip).

 DO NOT place the heater near a bed because objects such as pillows or blankets can fall off

the bed and be ignited by the heater.

 NEVER use this heater in bathrooms, laundry rooms, or any other location where the heater

could fall into a bathtub or pool, become damp, or come in contact with water.

 AVOID FIRE! Regularly inspect all air vents to make sure they are free from dust, lint, or other

blockage. Unplug the unit and clean with a vacuum ONLY. DO NOT rinse or get wet.

 ALWAYS attach all four legs before plugging in or turning on this heater! Failure to do so

could result in fire.

 NEVER plug in or turn on this heater with the air vents touching the ground! Doing so could

result in fire.

3

WARNING

 For residential use only! NOT for commercial use! Any commercial or public use of this

electrician inspect and/or replace the faulty outlets.

prongs: two flat blades (live and neutral) and one

slot receptacle is not

be used. The adapter

heater voids all warranties, and could cause injury.

 This product is not intended to be a primary heat source. It is for supplemental heat only.

 INDOOR use only! NEVER use this heater outdoors! Doing so may result in electric shock!

 Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside!

 NEVER modify this heater. Doing so could result in personal injury or property damage.

Modification of this fireplace completely voids all warranties.

 ALWAYS turn this heater off before unplugging it from the outlet.

 ALWAYS disconnect this unit from the power supply before performing any assembly or

cleaning, or before relocating the electric fireplace.

 NEVER leave this heater unattended. ALWAYS unplug this heater when not in use.

 ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.

 Place the heater near a wall outlet so an extension cord is not needed. If an extension cord is

needed, the gauge of the cord must be at least 14AWG, and the rating must be at least
1875 Watts. NEVER use a smaller gauge cord with a lower rating. Doing so may result in
fire or electric shock.

 ONLY use this heater on a minimum 120V AC 15-Amp grounded circuit. NEVER overload

the circuit. If this heater trips the circuit breaker, or blows the fuse, unplug it and all other

appliances on the same circuit before the next use.

 NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or

connections. Plugging this heater into a faulty outlet could result in electric arcing within the
outlet that could cause the outlet to overheat or catch fire.

 ALWAY S check your heater cord and plug connections with each use!

i) MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs

can cause the outlet to overheat.

ii) Heaters draw more current than small appliances. Overheating may occur even if it has

not occurred with the use of other appliances.

iii) During use check frequently to see if the plug outlet or faceplate is HOT!

iv) If the outlet or faceplate is HOT, discontinue use immediately and have a qualified

 The power cord supplied with the heater has three

round pin (ground). If a 3­available, an adapter MUST
MUST be properly grounded to the outlet box (see
figure at right). [NOTE: Adapter NOT INCLUDED.]

 SAVE THESE INSTRUCTIONS!