XAVi XW101MY User Manual

XA Vi Technologies Corporation
Tel: [phone]
Fax: [phone]
9F, No. 129, Hsing Te Road, Sanchung City,
Taipei County 241,
Taiwan

Copyright © 2005, XAVi Technologies Corporation

Information in this manual is subject to change without notice. No part of this
manual may be reproduced or transmitted in any form or by any means,
electronic or mechanical, including photocopying or scanning, for any purpose,
without the written permission of XAVi Technologies Corporation.

XAVi Technologies Corporation provides this documentation without warranty
of any kind, implied or expressed, including, but not limited to, the implied
warranties of merchantability and fitness for a particular purpose.

2

CERTIFICATION NOTICE

Federal Communications Commission Compliance Notices

To ensure continued compliance, use only shielded interface cables when
connecting to the computer or peripheral devices. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
This device complies with 15 of the FCC Rules. Operation is subject to the
following two

Federal Communication Commission (FCC) Statement:

NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.

The antenna(s) used for this transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.

The manufacture is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.

3

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.

This device is intended only for OEM integrators under the following
conditions:

1) The antenna must be installed such that 20 cm is maintained between the
antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or
antenna.

3)

As long as 2 conditions above are met, further transmitter
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.

test will not be required.

(for example

be used on the

4

Table of Contents

CERTIFICATION NOTICE .............................................3

Federal Communications Commission Compliance Notices.....3

Federal Communication Commission (FCC) Statement:............3

INFORMATION TO USER ............................................. 6

Introduction............................................................................................6

Package Contents................................................................................6

System Requirements.........................................................................6

How to Install XW101M:............................................... 7

Phase I -Install XW101M Driver.....................................................7

Phase II -Install XW101M Hardware Winzard..............................9

Troubleshooting......................................................... 12

5