Page 1
INSTALLATION INSTRUCTIONS
BYPASS94
IR BYPASS KIT
The BYPASS94 routes Infrared control signals around RF amplifiers and non-DC passing splitters.
RF
CPL10 COUPLER
IR
Short Coaxial Jumper Cables
3.5/3.5mm Mono Mini Plug Cable
RF/IR
CPL10
Couplers
RF
CPL10 COUPLER
IR
RF/IR
BYPASS94 Kit Parts
The kit includes the following parts:
2- CPL10 RF/IR Couplers
2- Short coaxial jumper cables, with "F" connectors on each end.
1- Connector cable with 3.5mm mono mini plugs on each end.
INSTALLATION
The following diagram illustrates how to connect the kit parts into a coaxial line to route the IR control signal
around an RF amplifier in an RF system.
Coaxial cable
to IR receivers
and TVs
CPL10
RF/IR
RF
CPL10 COUPLER
Short Coaxial
Jumper Cable
IR
RF Amp
INOUT
Short Coaxial
Jumper Cable
Accessories
IMPORTANT: Be sure that the IN and OUT terminals of the RF Amp are connected to the terminals marked
"RF" on the CPL10 Couplers.
Use the same technique to bypass non-DC passing splitters or other RF devices.
10-19-99
3.5/3.5mm Mono
Mini Plug Cable
RF/IR
RF
CPL10 COUPLER
IR
CPL10
Coaxial cable
from IR controlled
RF sources
1
Loading...