Xantech 598-00 User Manual

INSTALLATION INSTRUCTIONS

598-00

EIGHT BUTTON DRY CONTACT KEYPAD

• The 598 is an eight button, momentary, dry contact keypad. It is normally used in conjunction with the
Xantech 590 Programmable Controller as shown in the illustration below.

• Requires 9-conductor cable, as shown. Use 24 gauge, stranded or solid wire, up to lengths of 5000'.

• Two 598's may be used to provide momentary switch closures for all 16 of the 590 input terminals.

• Two or more 598's may also be wired in parallel to the same terminals on the 590 where control from more
than one room or area is required.

• The 598 fits into a standard single-gang J-box. 598's may also be used side-by-side in two (or more) gang
J-boxes.

• A legend cutout sheet (included) contains typical component function command icons for button
identification.

Controllers

C

1
2
3
4
5
6
7
8

Model 598

Key Pad

(rear view)

+12V DC

Wire size typically AWG 20-24

+

1

234567891011 141516OG

–

12 13

White Striped

Ground or "–"

Side (output)

return wires.

Model 590

(rear panel)

RES DEL SEQ PGM

12VDC

–+

ON

1234

BANK

12VDC

786-00

Power

Supply

5-14-99

Emitter, Connecting Block, etc.



To 120 V AC

Unswitched

1