Page 1
MODEL
28DES
Designer Emitter Shield
INSTALLATION INSTRUCTIONS
DESCRIPTION
The 28DES is a black (IR opaque) 1” x 2” shield that fits
over both the Xantech Designer Emitter body and the IR
sensor window of a controlled component. An optional
accessory, it prevents unwanted external IR signals from
passing through it or leaking past it.
The 28DES also prevents IR from the Designer Emitter from
radiating backwards into the IR sensors of other
components. It is especially useful for zone controlled
applications where you want the equipment controlled only
by the Designer Emitter fastened over the component IR
sensors.
INSTALLATION
1. Before removing the adhesive covers from the
shield or the emitter, fit them together and
temporarily position them over the IR sensor
window of the component.
2. When you have accurately determine the correct
position for them, neatly trim the shield (if needed)
being sure that you leave sufficient material to
overlap the extremities of the equipment’s IR
sensor window.
3. Remove adhesive covers from the shield and the
emitter and stick them onto the IR sensor window.
13100 Telfair Ave. 2F, Sylmar CA 91342 | Xantech.com
Xantech Corporation
Installation Instructions, 28DES © 2008 Xantech Corporation
Document # 08905173B
This document is copyright protected. No part of this manual may be
copied or reproduced in any form without prior written consent from
Xantech Corporation. Xantech Corporation shall not be liable for
operational, technical, or editorial errors/omissions made in this document.
Loading...