XAC Automation XUPT303 User Manual
UNATTENDED TERMINAL XUPT-303
INSTALLATION GUIDE
1. XUPT-303 PACKAGE CONTAINS
- xUPT-303
- Cable clamp (Figure 1)
- 2 Hand screws (Figure 2)
- 2 RS232 to RJ 12 cable (Figure 3)
- P90 dedicated cable (Figure 4) – Used to connect and supply power to XAC P90 (Optional)
Figure 1 Figure 2 Figure 3 Figure 4
2. PORT CONFIGURATION
There are several ports at the back side of terminal (Figure 5).
- Power jack
- 1 Ethernet port
- 3 COM port
- 4 USB port
- 1 mini USB port
NOTE: COM3 port is dedicated to XAC Secure Hybrid Reader module.
Power Input Requirement:
Figure 5
Input: 12Vdc/3A
3. REMOVAL PROTECTION
Two “Removal Protection” sensors (Figure 6) are located at the right side of front. When install
this module, make sure these two sensors are pressed firmly against kiosk bezel.
Figure 6
4. CABLE MANAGEMENT
Step 1: Place the cable clamp on top of cable management channels. The tip on clamp should be
aligned to the hole on xUPT-303 (Figure 7)
Loading...