d
XC
60
TERMINAL PAYMENT CRADLE
INSTALLATION GUIDE
1. P
ACKAGE CONTENT
2. D
EVICE OVERVIEW
Device Overview (Figure 1):
XC60
Power adaptor
REAR SIDE
Figure 1
BACK AREA
1 COM1
2 COM2
3 USB Host
4 LAN
FRONT SIDE
Figure 2
FRONT AREA
5 Charging Contact
6 Status LED
LEFT SIDE
Figure 3
SIDE AREA
7 DC JACK
■
XC60 Power spec:
Input: 12V DC, 2A
■
Power Adapter spec:
Input: 100 ~240 ac
Output: 12V DC, 2A min
This symbol is intended to alert the user before starting using the POS.
Caution: This product shall be only used with a certified power supply unit which was
investigated according to the standard of IEC 60950-1, UL 60950-1 and CAN/CSA C22.2 No.
60950-1-07, and marked “I.T.E. LPS”, and with operating temperature: minimum 40°C, output
rated: 12V DC, minimum 2 A.
Operating Temperature: 0
3. P
OWER ON/OFF THE DEVICE
To power ON the device: Plug-in the DC JACK
To power OFF the device: Un-Plug the DC JACK
o
C to 40oC
Figure 4
4. LED B
Insert Power adapter and device will power up, there is a LED status:
EHAVIORS
Location:
Top right corner (Figure 5)
Figure 5
Blinking Red - System update process
Solid Red - System errors and can’t operation
Solid Orange – System power on
Solid Green – System power on and under connection
Blinking Green – System power on and in idle mode
5. C
ONNECT WITH X
Place xCL_AT-150/xCL_AT-100 on the XC60 for charging and as Figure 6.
CL_AT-150/XCL_AT-100
Figure 6
F
EDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be
disclosed, distributed or reproduced without permission of XAC Automation Corporation.
XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein;
nor for incidental or consequential damages resulting from the furnishing, performance or use of his material.
XAC Automation Corporation
886-3-577-2738
www.xac.com.tw
Loading...