XAC Automation XAPT103WIFI3G User Manual























ALL IN ONE PAYMENT TERMINAL

INSTALLATION GUIDE

















MODEL:
xAPT-103





xAPT-103WiFi
xAPT-103WiFi.3G
xAPT-103LAN



1. BEFORE STARTING

Open the gate behind the device (Figure 1), and find the power input on the right side of the
terminal. Connect the plug from the power adapter into the power input (Figure 2). Plug the
power adapter into a 120-volt electrical outlet or into a surge suppressor (recommended) after the
power cord is connected to the power adapter.

Figure 1 Figure 2

 Operating Temperature: 0 °C to 40 °C
 Modem Speed: V.22bis 2400bps/ V.32bis 14400bps
 RTC battery spec. : 3V, CR2032

Caution: The cover (Figure 5) shall be provided with a means to keep it closed during normal
operation.
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used
battery according to the instructions.
Warning: A shielded-type power cord i s required in order to meet FCC emission limits and also
to prevent interference to the nearby radio and television reception. It is essential that only the
supplied power cord be used.

Connect one end of the phone cord into one of the jacks on the back of the terminal (Figure 3).
Plug the other end of the cord into a modular wall jack (Figure 4). Use only a jack for an analog
line like a fax line or a standard telephone.

Figure 3 Figure 4

(Optional) This terminal supports three USB ports. Two USB host ports locate on the back of the
terminal (Figure 5). One USB device port locates on the left side of the terminal (Figure 6). If the
terminal uses a peripheral device with USB connector, plug it into the USB host port.

(Optional) This terminal supports one RS-232 ports of RJ-12 offset keyed connector. If the terminal
uses a peripheral device with this type of connector and interface, plug it into the RS-232 port on
the back of the terminal (Figure 7).

(Optional) If the terminal needs communication over Ethernet, plug cable into the RJ-45 port on
the back of the terminal (Figure 8).

(Optional) The terminal supports GSM/3G M2M wireless communication and the SIM card slot

locates on the left side of the device (Figure 9). There are 4 SAM slots on the left side and SAM 4

also supports SIM slot function. Insert the SIM card into the SIM card slot (SAM 4) to
communicate with GSM/3G (Figure 9). Make sure SIM card is inserted in the right direction.