XAC Automation XAPT103PUWT User Manual















ALL IN ONE PAYMENT TERMINAL

INSTALLATION GUIDE



MODEL:



xAPT-103PUW



xCE_T103PUW



FD410

1. BEFORE STARTING

The power input is on the left side of the terminal (Figure 1). Connect the plug from the power
adapter into the power input (Figure 2). Plug the power adapter into a 120-volt electrical outlet or
into a surge suppressor (recommended) after the power cord is connected to the power adapter.

Figure 1 Figure 2

 Adapter spec:

Input: 100-240Vac, 50/60Hz 1A Output: 12Vdc, 3A

 RTC battery spec.: 3V, CR2032
 Operating Temperature: 0 °C to 40 °C

Caution: The cover (Figure 5) shall be provided with a means to keep it closed during normal
operation.
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used
battery according to the instructions.
Warning: A shielded-type power cord i s required in order to meet FCC emission limits and also
to prevent interference to the nearby radio and television reception. It is essential that only the
supplied power cord be used.

This terminal supports one USB port. The USB host port locates on the left side of the terminal
with a protected cover (Figure 3). If the terminal uses a peripheral device with USB connector,
plug it into the USB host port (Figure 4).

(Optional) The terminal supports for a variety of wireless communications to host machine (M2M)

including GSM 3G technology, Wi-Fi, and 3G+Wi-Fi combo solution. Open the battery

compartment cover behind the device (Figure 5), and find the SIM card slot on the right side of
the terminal (Figure 6). Insert the SIM card in to the SIM card slot to communicate with GSM/3G
(Figure 7). Make sure SIM card is inserted in the right direction.

Figure 5 Figure 6 Figure 7

Figure 3 Figure 4

2. POWER ON THE TERMINAL

Plug the power cord into the power jack and plug the power adapter into a 120-volt electrical
outlet or into a surge suppressor (recommended) after the power cord is connected to the power
adapter. Press the “Cancel” button at the front of device (Figure 8) until the system is booted up.