XAC Automation E25C User Manual

d

CHIP AND PIN MOBILE PAYMENT DEVICE XCE-25-C

INSTALLATION GUIDE

1. B

EFORE STARTING

There is a micro USB port (Figure 1) covered under the protection cover (Figure 2); this port is
used for battery charging, debugging, firmware update and key injection.

NOTE: The battery of xCE-25-C is built-in and rechargeable.

Figure 1 Figure 2

 Operating Temperature: 0
 Battery Pack: 3.7V, 1050mAh
 Input: 5V, 500mA

2. P

OWER ON/OFF THE DEVICE

To power on the device, press and hold the Power key for five seconds until the green LED
light flashes and the screen shows words. Once it is powered on, the LED will blink every five
seconds to indicate it is active.

To power off the device, press and hold the Power key for five seconds until the screen
become blank.

o

C to 40oC

Figure 3

NOTE: xCE-25-C will power off itself automatically if unused for 5 minutes.