XAC Automation 8006L23CR User Manual













"4-IN-1” EMV L1 & L2 PIN PAD

INSTALLATION GUIDE

































8006L2-3CR
QR Code Reader

1. 2 IN 1 CABLE INTRODUCTION

There are two model of communication interface for 8006L2-3CR w/QR code reader: USB
interface cable, RS232 interface cable.

¾ 2 in 1 USB 2.0 plug with Micro USB jack

USB 2.0 plug is mainly used to connect the device to PC for ActiveSync (Figure 1) while
micro USB jack is for power supply (Figure 3).

¾ 2 in 1 RS232 (DB-9) plug with Micro USB jack

It is mainly used to connect the device to PC for serial port communication (Figure 2) while
micro USB jack is for power supply (Figure 3).

Figure 1 Figure 2 Figure 3

 Input rating: DC 5V, 700mA (with QR module)
 Operating Temperature: 0ºC ~ 40 ºC

2. INSTALLING THE SAM CARD

Remove the back cover (Figure 4), and then slid in the SIM card and make sure the card is
installed correctly (Figure 5). Close the back cover to complete SAM card installation.

Figure 4 Figure 5

Caution: The cover (Figure 4) shall be provided with a means to keep it closed during normal

operation.

3. 8006 PIN PAD DEVICE READY

The unit automatically starts up when connected the power on Ethernet cable. Upon startup, the
PIN Pad device displays the default screen as Figure 6.

Figure 6

4. USING THE CARD READER

¾ Magnetic Stripe Reader

Find the card reader slot at the right side of PIN Pad. Slide the card in either direction
through the slot without stopping. If the card swipe fails, check the position of the