XAC XCL_T305 Installation Manuals

UNATTENDED TERMINAL

XCL_T305

INSTALLATION GUIDE

1.

X

CL_T305 P

ACKAGE CONTAINS

- xCL_T305 (also called T305)

- Cable clamp (Figure 1)

- 2 Hand screws (Figure 2)

- 2 RS232 to RJ 12 cable (Figure 3)

- Water proof cover (Figure 4)

- P90/P95 dedicated cable (Figure 5) – Used to connect and supply power to XAC Secure Hybrid

Reader (Optional)

- Power adaptor & power cord (Optional)

Figure 1 Figure 2 Figure 3 Figure 4 Figure 5

2. P

ORT CONFIGURATION

There are several ports at the back side of terminal (Figure 6).

- Power jack

- 1 Ethernet port

- 3 COM port

- 4 USB port

- 1 mini USB port

NOTE: COM3 port is dedicated to XAC Secure Hybrid Reader module.

Figure 6

 Power Input Requirement:

Input: 12Vdc/3A

 Com Port Power output Requirement:

Output :12Vdc/1A(total three com ports)

 Power Adaptor spec.

Input: 100 ~240 ac
Output: 12V DC, 3A

This symbol is intended to alert the user before starting using the POS.

Caution: Use only the AC power adapter approved and provided by XAC Automation

Corporation for use with this device. Use of any other AC adapter may cause a risk of fire or
explosion.

Caution: This product shall be only used with a certified power supply unit which was

investigated according to the standard of IEC 60950-1, and marked “I.T.E. LPS”, and with
operating temperature: minimum 40°C, output rated: 12V DC, minimum 3A.

 Operating Temperature: 0

o

C to 40oC

3. R

EMOVAL PROTECTION

Two “Removal Protection” sensors (Figure 7) are located at the right side of front. When install
this module, make sure these two sensors are pressed firmly against kiosk bezel.

Figure 7

4. I

NSTALL

T305

ON YOUR KIOSK

Step 1: To fix T305 & P95 on a kiosk's front panel, please make sure the surface is plate and refer

to below screw locations and torque value.

Step2: Check all the screw holes of T305 to avoid any damage.

Step3: To make the fixing points on the kiosk, please refer to Figure 8.

Step4: Lock 12 screws by following the sequence shown in Figure 9, and contact the rubber with

kiosk cover closely. (NOTE: Torque 4~4.5 kgf-cm for each screw to fix.)

The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed,

distributed or reproduced without permission of XAC Automation Corporation.

XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein; nor for

incidental or consequential damages resulting from the furnishing, performance or use of his material.

XAC Automation Corporation
886-3-577-2738
www.xac.com.tw