XAC XCL_AT-170 Installation Manual

d

INSTALLATION GUIDE

TERMINAL PAYMENT DEVICE

XCL_AT-170

1. PACKAGE CONTENT

2. DEVICE OVERVIEW

AT-170 Key Buttons & Interface Ports (Figure 1)

Figure 1

RONT AREA

1

7” Touch Display

2

Printer Paper Cover & Contactless Card Tapping Area

3

Barcode scanner (Optional)

4

Smart Card Reader (SCR) slot

REAR AREA

5

Battery Compartment

6

Charging Contact

RIGHT SIDE

7

Magnetic Strip Reader (MSR) slot

8

Power Button (Press > 3 seconds to power on/off)

9

USB port (type C) for charging and data transfer

FRONT

REAR

 AT-170

 Power adaptor

(Optional)

 USB cable

 Paper Roll

Right Side

■ AT-170 Power spec:

Input: 5V DC, 2A

■ Power Adapter spec:

Input: 100 ~240 Vac
Output: 5V DC, 2A

This symbol is intended to alert the user before starting using the POS.

Caution: Use only the AC adapter approved and provided by XAC Automation Corporation

for use with this device. Use of any other AC adapter may cause a risk of fire or explosion.

 Operating Temperature: 0

o

C to 40oC

3. POWER ON/OFF THE DEVICE

To power on the device: Long press the Power key (Figure 2) > 3 seconds until a buzzer sound
is heard, and screen is activated.
To power off the device:

1) Press the Power key > 3 seconds to shut down the device.

2) No action on device after 30 minutes

Figure 2

NOTE:

1. When there is no action on AT-100 after 2mins (adjustable), the device will enter sleep

mode. Please short press power button to wake up the device.

2. Long press for 10 seconds for Force Power Off.

4. USING THE MAGNETIC CARD READER

Swipe the card through the slot with magnetic stripe side facing the opposite direction of the
display. (Figure 3)