X6D X105RF, AD025RF User Manual

XPAND Light 3D Glasses (RF)

Model No. X105-RF-X1 (3D Glasses) and AD025-RF-X1 (RF-emitter)

User Guide

manual-X105-RF-X1-xpand.indd 1 28.9.2012 9:51:21

manual-X105-RF-X1-xpand.indd 2 28.9.2012 9:51:21

Glasses Overview

(1) Button (ON, OFF, Pairing) – located at the inner side of right earpiece.
(2) LED – located at the outer side of right earpiece, near earpiece hinge.

Turning ON Your Glasses

» Shortly press button once.
» Red LED will ramp from off to bright.
» If glasses cannot fi nd 3D host within few seconds LED will ramp from bright to

off and glasses will automatically shut down. If glasses fi nd the host they will
automatically connect to it, indicating by lit LED for 1 second.

Turning OFF Your Glasses

» Shortly press button once.
» Red LED will ramp from bright to off.
» Glasses will shut down.

Proximity Association with 3D RF Host

This procedure shall be done every time the glasses are introduced to new RF (radio
frequency like for example Bluetooth®) 3D host. During the proximity association, 3D
glasses shall be located within 1m from 3D RF host (3D TV, Emitter…).

» Switch on the glasses (1 short press).
» LED will ramp from off to bright, indicating glasses power on.
» Press button for minimum of 1 second.
» After 1 second, LED will start to blink with a rate of 1 blink per 2 seconds.
» Release the button.
» Successful proximity association is indicated with 6 short LED blinks.
» If glasses could not proximity associate LED will ramp from bright to off and

glasses will go in power off state.

© XPAND, All Rights Reserved. 1 www.xpand.me

manual-X105-RF-X1-xpand.indd 1 28.9.2012 9:51:22