X-1 (H2O Audio) XB1-BK-X User Manual

FRONT VIEW BACK VIEW

Customer Support is available:
Monday - Friday 9

P. 800.708.6080 or 858.623.0339

AM to 5PM PT

www.X-1.com

E. [e-mail]

AMPHIBX FIT

SPORT ARMBAND

WATERPROOF

WEATHERPROOF

SWEATPROOF

FITS IPOD®, IPHONE® AND MOST SMARTPHONES

FOR THE MOST UP TO DATE MANUALS PLEASE VISIT US AT WWW.X-1.COM/MANUALS

INSTALLING YOUR DEVICE

1. Pull the latch hook away from the lid. 3. Plug in 3.5mm Stereo Cable from

5. Arrange any excess cord so that it
will not interfere when closing the lid.

2. Holding latch hook open, lift on the tab of the lid.

6. Before closing the lid, ensure the seal is clean,
seated properly and that there is nothing in the way
that would prevent the lid from fully closing. Close lid.

inside the armband into your device.

7. Once lid is closed, double check that
the lid is fully seated, and that the latch
has snapped into place. Failure to do so
could cause the lid to open during use.

D-Ring

ClearTouch Pouch

Stereo Plug Cable

4. Slide device inside and align device in the
ClearTouch Pouch.

in the Amphibx Fit, orient the device in the armband to
ensure the camera lens is visible.

8. Always check your armband for obvious signs of
wear and check with Customer Service if you have any
questions about the condition of your armband.

take care of your Amphibx Fit, it will take care of you!

Removable Armstrap

Note: To use your device’s camera

If you

LatchTight Locking Lid

SealTight Connector Boot

Stable Fit Buoy

Waterproof Weld

ClearTouch Pouch

RINSABLE

SUBMERSIBLE
WATERPROOF

TOUCHSCREEN AND

CAMERA FRIENDLY

FLOTATION

BUOY

CHECKING THE WATERPROOF SEAL

The X-1 Amphibx Fit Sport Armband features a removable seal that forms a
waterproof barrier between the base and lid of the armband.

It is extremely important that special attention is paid to ensure the seal is
completely seated in the groove of the lid. If the seal is loose, out of alignment,
twisted or pinched in any way, it will compromise the waterproof integrity of the
armband and should not be used. Any debris such as hair, sand, surf wax or mud
will prevent it from forming a watertight barrier and should be cleaned off before
use.

It is extremely important that you ensure the seal is clean and properly seated each time
you close the lid. Failure to do so may ruin your device in the armband.

Waterproof Seal

If the seal comes out of alignment, carefully place it back into the groove, ensuring
all 4 corners are correctly installed. Close the lid into the base and then re-open it
to make sure the seal is fitted correctly into the groove. The seal should appear
straight and uniform along all edges and should not fall out easily.

INTRODUCTION

The X-1 Amphibx Fit Sport Armband allows you to utilize all of your favorite
features on the iPhone

®

, iPod touch®, most other MP3 players and smartphones in,

around and underwater.

USING YOUR WATERPROOF ARMBAND

We have tested your Amphibx Fit to be waterproof to a depth of 12 ft. prior to
making its way to you. Even so, we strongly recommend that you test it yourself
according to the following instructions, making sure that you understand how to
properly prepare it for use in the water. We recommend that you test the product
without a phone or media player inside before initial use.

1. Open the LatchTight Locking Lid.

2. Verify the seal area is clean and free of debris or damage.

3. Close and lock the armband without a phone or media player inside.

4. Plug in X-1 Waterproof Headphones (sold separately) to the SealTight

Connector Boot

5. Submerge the system in water and soak for 30 min.

6. Manipulate the pouch during submersion.

7. Remove from water and dry exterior so water does not fall inside when opened.

8. Before opening, check to see if there is water inside the armband.

9. Open the armband and ensure there is no water inside.

DO NOT USE IF WATER IS FOUND INSIDE PLEASE CONTACT X-1 CUSTOMER SUPPORT IMMEDIATELY.

CHECKING THE WATERPROOF WELDS

In addition to the waterproof seal
in the lid, the Amphibx Fit
Armband features welded outer
seams that have been specifically
designed to prevent water from
entering the armband.

Each X-1 armband is inspected
and tested in a pressure chamber
to ensure it is 100% waterproof
prior to packaging.

Even with this level of care, you
still need to ensure the welds have
not been damaged by your
activities.

Take a moment to look at the
waterproof welds upon arrival. You
should perform a visual inspection
of the welds each time you install
your device in the armband.

CONNECTING YOUR HEADPHONES

The SealTight Connector Boot featured on the Amphibx Fit is designed to create a
100% waterproof connection with X-1 Waterproof Headphones (sold separately). If
a SealTight Connector Boot is NOT installed the connection is NOT Waterproof.

The armband should not be submerged under water for long periods of time without
X-1 Waterproof Headphones plugged in as water could enter the armband through
the headphone jack.

X-1 Waterproof Headphones come with a strain relief in 2 different sizes. We have
included 2 SealTight Connector Boots for you to use based upon which X-1
Waterproof Headphones you have. Please see the images shown to see which
boot goes with which headphone plug.

The longer the armband is submerged underwater, the higher the possibility water can enter the
armband through the stereo jack. If headphones detach from the armband, we suggest getting
that connection back together as soon as possible.

3. What headphones are compatible with X-1 Waterproof Armbands?

X-1 Waterproof Armbands are designed to work with X-1 Waterproof Headphones and standard

3.5mm headphones.The armband should not be submerged underwater for long periods of time
without X-1 Waterproof Headphones plugged in as water may be able to enter the armband
through the stereo jack. IMPORTANT: X-1 Waterproof Armbands and Cases are compatible

with H2O Audio Waterproof Headphones.

4. Can X-1 Waterproof Armbands be taken into a hot tub or sauna?

Sometimes. Since we do not control the laws of physics, so you should continuously check to
see if condensation is forming inside the armband. This amount will vary from location to
location based upon the humidity in the air when the armband was originally closed. If any
condensation becomes visible within the armband, STOP use immediately.

NOTE: For more FAQs please visit www.X-1.com/faq

INSTALLING REMOVABLE SPORT ARMSTRAP

The Amphibx Fit Armband features a removable armstrap. Attach the armstrap to
the armband as shown. Note: Once fully assembled, slide armband up into place
on arm and tighten.

SAFETY INFORMATION

Please read this manual carefully. If you have any questions please contact X-1 Customer
Service prior to use.

Improper use of this system may cause the user to make mistakes or decisions that may lead to
serious injury or death.

Always make sure to have the audio player volume turned to zero and the headphones turned
away from the ears when turning on the audio player. If the volume level is not zero when the
audio player is turned on, it may cause ear injury due to a sudden burst of volume. The volume
should be slowly increased with an audio track playing to set the speaker volume to comfortable
output levels prior to positioning the headphones next to the ears. Hearing experts advise
against continuously loud and extended play. If you experience ringing in your ears, reduce
volume or discontinue use.

It can be potentially dangerous to use headphones while engaging in activities that require your
full attention. You should exercise extreme caution or discontinue use in potentially hazardous
situations. Do not use the headphones while driving, cycling, or operating any motorized vehicle.
It may create a traffic hazard and is illegal in some areas. Those users that elect to utilize this
system at, or near, the water’s surface, must maintain safety awareness of moving water crafts.

WARNING: Ear tips should always be used.

WARNING: Contains small parts which may be a choking hazard.

Not suitable for children under 3 years old.

WARNING: This product contains magnetic material.

CONTROLLING YOUR IPHONE, IPOD TOUCH, OR OTHER DEVICES

The ClearTouch Pouch has been engineered to allow you to maintain complete
control over touch controls and push buttons featured on your device.

The ClearTouch Pouch was designed to be clear on both sides so when oriented
properly, you can use the camera on most devices including all iPhone models, the
iPod touch (4th Gen.) and many other devices.

MAINTAINING YOUR AMPHIBX FIT WATERPROOF ARMBAND

Your Amphibx Fit was specifically engineered to be durable enough to handle
damaging environments such as the pool, ocean, rain, and mud, yet made to be
light enough for everyday uses such as running, swimming, biking, hiking, and just
relaxing at the beach. With that said, it is not indestructible, so you need to use
reasonable care when using the Amphibx Fit.

With so many environments, and so many uses, the one common message is that
you should always check the Amphibx Fit before use to make sure it was not
damaged during your last activity.

Do not expose the armband to extreme heat, such as the inside of a hot car, or in
hot direct sunlight, such as on a beach, or boat deck. Doing so may cause damage
and subsequent flooding.

1 YEAR LIMITED WARRANTY

X-1 Audio, Inc.’s one year limited warranty covers defects in materials and/or workmanship of all
X-1 branded product for 1 year from the date of original purchase. This warranty does not apply
to any products which have been neglected, altered, abused, used for a purpose other than the
one for which they were manufactured, repaired by customer or any party without X-1’s written
authorization, or used in any manner inconsistent with X-1’s instructions. Please refer to the care
and maintenance instructions for more details. Product manuals are available for download at
www.X-1.com/manuals on the X-1 website as well as packaged with the product.

Products must be purchased from an Authorized Dealer. This limited warranty is not valid for
product purchased through an unauthorized source. For a directory of X-1 Authorized Dealers,
please visit the store locator section on the company website. If you have questions as to
whether or not a dealer is authorized, please contact Customer Support.

X-1 will, at its sole discretion and without charging the customer, repair or replace any product
components that fail in normal use during the limited warranty period. The customer will be
responsible for the cost of shipping the product to X-1. X-1 will pay the cost of returning the
repaired or replacement product to the customer. IN NO EVENT WILL X-1’S LIABILITY TO
CUSTOMER EXCEED THE PURCHASE PRICE OF THE SPECIFIC PRODUCT SUBJECT TO
THE WARRANTY CLAIM.

The warranty is valid only for the original owner who purchases the product from an Authorized
Dealer. Transfers do not qualify for warranty protection.

X-1 reserves the right to replace any out-of-stock, discontinued, or limited edition product with a
comparable product. Discontinued products may not be available for warranty replacement.

After in-water use, you should rinse your armband off with clean water and let it air
dry for your next use. Strong detergents, soaps, and chemicals must never be
used to clean the armband. For long-term storage, store out of direct sunlight.

MAINTAINING THE WATERPROOF SEAL

To clean the seal, remove it from the armband and wash with warm fresh water.
Strong detergents, soaps, and chemicals should never be used to clean the seal.
Allow seal to air dry and install back into the armband once dry. The life of a
waterproof seal is typically one year. Please contact X-1 Customer Support for
replacement seals. The silicone seal does not require lubrication. Do not use
silicone grease to lubricate the seal.

FAQ

S

1. What MP3 players and phones are compatible with this armband?

The Amphibx Fit armband for large devices was designed specifically for the Apple iPhone and
iPod touch. However many smartphones and portable media players will fit into this armband
because of the generous size of the opening and the flexible materials used. If your device does
not fit, please let us know so we can consider it for future products.

2. What happens if the waterproof headphones become disconnected from
the armband?

As long as the armband is not submerged underwater for long periods of time, it should be fine.

TO THE EXTENT PERMITTED BY LAW, THIS WARRANTY IS THE SOLE AND EXCLUSIVE REMEDY AND IS

IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE

IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO

EVENT SHALL X-1 AUDIO, INC. BE LIABLE FOR ANY INDIRECT, PUNITIVE, INCIDENTAL OR

CONSEQUENTIAL DAMAGES, PERSONAL PROPERTY CLAIMS REGARDING THIRD PARTY PRODUCTS,

OR SPECIAL DAMAGES, REGARDLESS OF WHETHER A CLAIM FOR SUCH DAMAGES IS BASED ON

WARRANTY, CONTRACT, NEGLIGENCE OR OTHERWISE. SOME STATES DO NOT ALLOW A LIMITATION

ON THE DURATION OF IMPLIED WARRANTIES OR THE EXCLUSION OR LIMITATION OF INCIDENTAL OR

CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

RETURN AUTHORIZATION

Prior to any return, a Return Authorization (RA) number must be obtained. To receive an RA
number, go online to www.X-1.com/ra and follow the instructions on how to return a product.
Proof of purchase from an Authorized Dealer will be required.

Copyright Notice: This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied,
photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. The X-1
name, logo, and trade dress are trademarks of X-1 Audio, Inc. Apple, iPod and iPhone are trademarks of Apple Inc.,
registered in the U.S. and other countries. Apple is not responsible for the operation of this device or its compliance
with safety and regulatory standards. X-1 products are protected by US Patents 6396769, 6614722, 6954405,
7263032, 7535799, 7755975, 8223997 and others pending.