X-1 (H2O Audio) S6-1A3 User Manual

!

WARNING

!

H2O Audio stands behind our products.

Failure to follow our instructions could destroy

your iPod and will void the Warranty. If you

have any concerns, or experience any

difficulties with your H2O Audio product, we

are here to help you, so please contact us

directly. We can be reached at:

1.800.708.6080

[e-mail]

www.h2oaudio.com

Important Information
About Your T -Seal

The most important feature of
your new H2O Audio housing is
the removable T-Seal that forms
a waterproof barrier between
the base and lid of the housing.
It is up to you to check that the
seal has not slipped or become
out of alignment every time you
install your iPod in the housing.

H2O Audio stands behind the
products we sell, but they will
only work if you use them
correctly. By following these
instructions we know you will
enjoy your iPod in the water like
we do.

H2O Audio:

1.800.708.6080

858.623.0339
[e-mail]
www.h2oaudio.com

**Please remember REMOVE this paper
before using**

S9 - 73 20070423

Caution

Failure to use this product

correctly voids your Warranty

and could destroy your iPod

READ ALL INSTRUCTIONS

Correct

The dotted lines in the photos below indicate

where the contact surface for the T-Seal is located

T-Seal must be installed completely in

all four corners of the housing.

Incorrect

This T-Seal is shown out of alignment

and will not protect the iPod from

water when closed.

This T-seal is correctly seated in a closed

housing, sealing the housing and

protecting the iPod from water.

side view

The misaligned T-Seal becomes pinched

between the base and lid (as Shown)

creating an opening in the housing that

will cause the housing to flood.