X10 Wireless Technology XX36A User Manual



Wired/Wireless IP Camera – Model XX36A

Quick Installation Guide

(Using IE Browser)

Introduction

You can acces s your came ra's liv e video fee d from your web brows er or thro ugh software on your com puter, your tablet, or
your smart phone.

To access your camera via Ethernet, to your desktop computer - Follow steps 1 – 3.

To access your camera via Wi-Fi, to your notebook via Wi-Fi and cell-phone via Wi-Fi - Follow steps 1 – 4.

To access your camera via W-Fi, to cell-phone via 3G/4G and computer over the Internet - Follow steps 1- 4 and then see the
full owner's manual for dynamic DNS and port forwarding, or use X10 iWatchMobile Pro software (visit www.x10.com).

Once you have your camera configured, you may access your camera by either of these methods:

1. Use the ipcamsetup program on the included CD and click on your camera.

2. Once you are viewing your camera's live video, you can save the web address as a favorite. Then you can use that saved
favorite without using the ipcamsetup program each time.

3. In your web browser, type the IP address of your camera as a new web address.

4. To use a friendly name like 'mylivingroom.dyndyns.org
Dynamic DNS.

5. To see your camera over the Internet, or from a cell phone through a 3G/4G connection, use iWatchMobile Pro software,
or see your owner's manual to configure your router for Port Forwarding.

', see the owner's manual for how to configure your camera to use

Page 1



Step 1: Hardware Installation

You need to set up your camera using a network cable (wired) first before you attempt to use it wirelessly. It is
recommended that you set the camera up indoors first, before routing the cables through an external wall to mount it
outdoors.

1. Install the Wi-Fi antenna.

2. Plug the power adap t or into the camera and into an AC outlet.

3. Plug one end of the network cable into the camera, and the other end into your router/switch.

Step 2: Software Installation

Install the following software:

1. IP Camera Tool: Open the CD, click “IPCamSetup.exe”—“Next”—“Next”—“Close”.

2. ActiveX: Click “Appinstall.exe”—“Next”—“Install”—“Finish”.

After this is done, the icon “IP Camera Tool”

will be displayed on your desktop.

Page 2