X10 LM465 INSTALL GUIDE

Lamp Module LM465

UNIT CODE

DIAL

Setting The Module’s Code

Using a small screwdriver, set the red
House Code dial to the same letter as your
Controllers. Set the Black Unit Code dial to
any unused number.

HOUSE CODE

DIAL

Ratings

The Lamp Module can be used to control an incandescent lamp rated up to
300W. It is not suitable for other types of lamps such as fluorescent or energy
saving lamps, low voltage lamps, or lamps that include a dimmer control.
Caution: Do not connect an appliance such as a coffee pot or heater to a Lamp
Module. It may damage the Module and/or the appliance and could cause a fire
hazard. Use an Appliance Module instead.

1. Set the House Code

and Unit Code.

2. Plug a lamp into

the Module.

3. Plug the Module into

the same wall outlet as
your controller (see
testing below).

Testing The Module

Check Out our Web site at:

http://www.x10.com

For more information on X10 products and

special promotional offers.

X10 Wireless Technology, Inc. Limited One Year Warranty

X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10
products to be free from defective material and workmanship for a period of
one (1) year from the original date of purchase at retail. X10 agrees to repair
or replace, at its sole discretion, a defective X10 product if returned to X10
within the warranty period and with proof of purchase. If service is required
under this warranty:

Call 1-800-442-5065, visit www.x10.com, or e-mail [e-mail].

Make sure the lamp’s switch is on. Plug the Module into the same wall outlet as
your controller, press the On and Off buttons on the controller that correspond
to the Unit Code setting on the Module. If the Module turns on and off you can
unplug the Module or Controller and move it to its permanent location. If you
can’t control the module, visit http://www.x10.com/support for help.

For help or more information on setup, please visit:

http://www.x10.com/support

LM465-11/02