X10 IN28A SETUP

Setting Up ScanCan Kit

Your new Scan Controller kit lets you take control
of your XCam2s and ScanCams! Used in
conjunction with your ScanCam or XCam2 with
Scan Pack add-on, you can use the camera remote
control (model CR12A) and transceiver (model
TM751) to turn one or several cameras on and
off remotely.

To get the most out of the Scan Controller kit and
multiple ScanCams, you should set the addresses
of the cameras within the following groups of four:
1-4, 5-8, 9-12 and 13-16.

Installation

Use a screwdriver to set the letter dial on the
TM751 to the same letter (A-P) as the cameras
you want to use the Scan Controller kit with. Plug

Addendum to CR12A Instructions

Important! The following steps in the
provided CR12A instruction sheet should
read as
follows:

In step 7, the
section stating
"Then,

pressing either
the blue UP or
DOWN buttons
scans forward
or backward
thru all 4
cameras. Each
Camera turns
on for a short
period of time
and then turns
off before the
next Camera
turns on."

should read
"Then,

pressing either the blue UP or DOWN
buttons will select the next or previous
camera in the group after turning the
current camera off."

Transceiver Module

the TM751 into an available 110V wall outlet. Next,
set the dial on the CR12A to that same letter. You
are now ready to turn your modules off and on.

To switch to a particular camera, hit the on button
for the address associate with that camera. To
view another camera, just hit the on button
for its address. See the CR12A instructions for
more details.

Step 9 should say "To change the group

of 4 codes for camera control from 1-4 to
5-8: press and hold the 5-ON button, then
flip the 1-8/9-16 switch to the and then
back to the left." The instructions for 10

and 11 should be changed similarly.

MODEL

NUMBER:

IN28A